Audiovox SP-11CD User Manual
DIGITAL AUDIO/COMPACT DISC CHANGER
SP-11CDP
COMPACT
DIGITAL AUDIO
10 DISC AUTO CHANGER
COMPACT DISC AUDIO CHANGER SYSTEM
MODEL SP-11CDP
10-DISC CD CHANGER
INSTALLATION MANUAL
PACKING LIST
MAIN UNIT
Changer
INST ALLATION P ARTS
Bracket
2 pcs
OPEN
Stud Bracket
2 pcs
DIGITAL AUDIO/COMPACT DISC CHANGER
SP-11CDP
COMPACT
DIGITAL AUDIO
10 DISC AUTO CHANGER
COMPACT DISC AUDIO CHANGER SYSTEM
Hexagonal Bolt
(M6 x 15)
4 pcs.
5 Meter Din Cable
1 pc.
Machine Screw
Screw Hole Cover Labels
(M4x 10)
4 pcs.
OTHER ACCESSORIES
CD Magazine (P/N SP11M)
1 pc.
1 pc.
Index seal sheet
Installation Manual
1 pc.
Hexagonal Nut
(M6)
4 pcs.
1 pc.
Owner's Manual
1 pc.
2
BEFORE INSTALLING THE UNIT
Transport Lock Screws
The mechanism in the CD changer is "locked" into place during shipment by the
transport screws. Be sure to remove the screws prior to installation.
l Caution l
After removing the transport lock screws, place a piece of masking tape over
each screw hole. The tape will keep out dust , which could cause the unit
to malfunction.
TRANSIT BOL TS
(2 RIGHT SIDE, 1 LEFT SIDE)
Installation and Wiring Precautions
To prevent a short-circuit,
1
l Be sure to turn off the ignition and remove the negative (-) battery cable, prior to installation.
l Connect power wires last.
Note
If the changer is to be installed in a car that is equipped with an on-board drive or navigation computer, do not disconnect
the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra
caution during installation, to prevent a short circuit.
Do not install the unit in the following locations.
2
l Locations exposed to direct sunlight.
l Where hot air is discharged from the car heater.
l In areas subject to extreme temperatures.
Incorrect installation can cause the sound to "skip" when playing a disc.
3
Mount the unit firmly in place, using the supplied brackets and screws.
Be careful not to damage the car wiring.
4
l Be sure to use the supplied screws.
5
l Be careful not to snag any wires when tightening screws.
l Do not use any of the screws that are part of the brake or steering system, to install the unit.
l This unit cannot be installed on either side or up-side down. Installation in such positions will cause the mechanism
6
to malfunction.
3
Loading...