Audiovox SP-10CD User Manual
SP-10CD
MODEL SP-10CD
10-DISC CD CHANGER
INSTALLATION MANUAL
PACKING LIST
MAIN UNIT
INSTALLATION PARTS
Changer
Bracket (L)
1 pc.
Self-tapping screw
(M5 x 12)
4 pcs.
OTHER ACCESSORIES
Bracket (R)
1 pc.
Hexagonal bolt with washer
(M5 x 10)
4 pcs.
Seals (A)
1 pc.
5 Meter Din Cable
1 pc.
Seals (B)
1 pc.
CD Magazine
1 pc.
Index seal sheet
1 pc.
Installation Manual
1 pc.
Owner's guide
1 pc.
1
BEFORE INSTALLING THE UNIT
Transport Lock Screws
The mechanism in the CD changer is "locked" into place during shipment by the
transport screws. Be sure to remove the screws prior to installation.
Caution
After removing the transport lock screws, place the supplied seals (A) over the screw
holes. These seals are used to keep dust out of the unit, which could cause a malfunction.
Installation and Wiring Precautions
To prevent a short-circuit,
1
Be sure to turn off the ignition and remove the negative (-) battery cable, prior to installation.
Connect power wires last.
Note
If the changer is to be installed in a car that is equipped with an on-board drive or navigation computer, do not disconnect
the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra
caution during installation, not to cause a short circuit.
Do not install the unit in the following locations.
2
Locations exposed to direct sunlight.
Where hot air is discharged from the car heater.
In areas subject to extreme temperatures.
Incorrect installation can cause the sound to "skip" when playing a disc.
3
Mount the unit firmly in place, using the supplied brackets and screws.
Be careful not to damage the car wiring.
4
Be sure to use the supplied screws.
5
Be careful not to snag any wires when tightening screws.
Do not use any of the screws that are part of the brake or steering system, to install the unit.
This unit cannot be installed on its side, end, or upside down. Installation in such positions will cause malfunctioning
6
of the mechanism.
2
Loading...