Audiovox AVD400TA User Manual
AVD400TA
SLOT-IN DVD PLAYER
WITH BUILT-IN TV TUNER
AVD400TA
DOLBY
DVDPLAYER
Owner’s Manual
A . Welcome
Thank you for choosing the AVD400TA DVD Player . The AVD400TA
is designed to optimize the enjoyment of your favorite DVDs in the
mobile environment. This DVD Player is constructed to provide years
of reliable, trouble-free service. Please read this manual thoroughly
prior to operating the player and save it for future reference.
B. Precautions
EXPLANA TION OF GRAPHIC SYMBOLS
The lighting flash with arrowhead symbol, within an equilateral
triangle, is intended to alert the user to the presence of
uninsulated ‘dangerous voltage’ within the product’s enclosure
that may be of sufficient magnitude to constitute risk of electric
shock to persons.
The exclamation point within an equilateral triangle is intended
to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying
the appliance.
WARNING:
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK. DO NOT
EXPOSE THIS DEVICE TO MOISTURE.
2
SAFETY PRECAUTION
For safety reasons do not allow children to unfasten seat-belts to change
video media or make any adjustments to the system. Enjoy your entertainment system but always remember the safety of all passengers is
the number one priority .
IMPORTANT NOTICE
It is unlawful in most states for a person to drive a motor vehicle which is
equipped with a television viewer or screen that is located in the motor
vehicle at any point forward of the back of the driver’s seat, or that is
visible, directly or indirectly , to the driver while operating the vehicle. In
the interest of safety, this system should never be installed where it will
be visible, directly or indirectly , by the operator of the motor vehicle.
1. OBJECTS AND LIQUID
Do not insert objects of any kind into the system through its openings; do not spill or spray liquid on or into the system (this may
result in a fire or electric shock). Do not place heavy objects on the
unit. T o ensure proper ventilation and proper operation, never cover
or block the slots and openings.
2. DISASSEMBLY
Do not attempt to disassemble the unit. There is a risk of electric
shock and/or exposure to Laser Radiation. Contact qualified service personnel if your system is in need of repair.
3. CLEANING UNIT
When cleaning, make sure the system is unplugged from the power
source. Do not use any solvents or cleaning materials. Clean the
DVD player using a lightly dampened lint free cloth to wipe the unit.
3
4. DISCS or (DISC Media)
Do not use irregularly shaped discs such as heart or star-shaped
discs as they may cause the unit to malfunction. Do not stick paper, t ape or glue on the disc. Do not expose the disc to direct sunlight or heat sources. Do not touch the surface of the disc. Handle
the disc by its edges. Clean the disc by wiping the disc from the
center out with a soft lint free cleaning cloth. Remove the disc from
the unit and store it in its case after playing. Some playback operations of discs may be intentionally fixed by software producers. Unit
plays discs according to the disc contents the software producers
designed therefore some playback features may not be available.
Refer to the instructions supplied with the discs.
5. Powering the DVD Player
This system MUST be powered from switched (Accessory) power
as indicated on the marking label. Power should be applied to the
unit when the ignition key is in the Run and/or Accessory positions.
Use only the supplied power cable provided with this set to avoid
electric hazards.
6. Operation
When the temperature rises dramatically from a very low temperature, moisture may condense inside the AVD400TA and cause the
DVD player to malfunction. If the A VD400T A does not operate properly under these conditions leave the AVD400TA turned on for at
least 30 minutes for the moisture to evaporate.
4
C. Contents
1. 1 Main Unit
2. 1 Remote control with one Battery
3. 1 12VDC Power Harness
4. 2 Brackets with 4 Screws
5. 1 Remote IR Receiver
6. 1 AV cable (RCA to RCA)
7. 1 Owner's Manual (not shown)
1.
DVDPLAYER
AVD400TA
DOLBY
3.
5. 6.
2.
AUDIOVOX
4.
X 4
5
D. Controls
Main Unit (Refer to Figure 1)
1. Power Button
2. Play/Stop/Memory Button
3. Mode Button
4. Remote Control Sensor
5. Video Input
6. Left Audio Input
7. Right Audio Input
8. Next Button
9. Previous Button
2
3
10. Eject Button
1 1. IR Input
12. Antenna Input
13. Audio R Output Jack
14. Audio L Output Jack
15. Video Output Jack
16. S-Video Output Jack
17. External Remote Eye Input
18. Digital Audio Output
19. DC In 12V Power Supply Connector
1
DVDPLAYER
AVD400TA
DOLBY
4
11
56
1
10
9
8
7
DOLBY
CCF
1213141516171819
Figure 1
6
E. Remote Control View (Refer to Figure 2)
1) MODE Button
2) POWER Button
3) MENU Button
4) UP/DOWN/
LEFT/RIGHT Button
5) ENTER/PLAY/ADD Button
6) VOLUME +/- Buttons
7) NUMERIC KEYPAD
8) 10+ Button
9) TITLE Button
10) AUDIO Button
11) REPEAT Button
12) SUBTITLE Button
13) DISPLA Y Button
14) EJECT Button
15) SETUP Button
16) P AUSE Button
17) STOP MEMORY Button
18) NEXT CH+ Button
19) PREVIOUS CH- Button
20) SCAN FORWARD Button
21) SCAN REVERSE Button
22) MUTE Button
23) GOTO Button
24) ZOOM Button
25) A-B REPEAT Button
26) ANGLE Button
27) SLOW Button
3
4
5
6
7
8
9
10
11 12
12
AUDIOVOX
27
Figure 2
13
14
15
16
17
4
(Ref)
18
19
20
21
22
23
24
25
26
7
F . Connections
DOLBY
AVD400TA DVDPLAYER
Front
Yellow Video Input (to DVD Player)
Red Audio In
White Audio In
DOLBY
1
CCF
Rear
TV Antenna
Yellow Video Out
(GND) Black
(ACC) Red
Red Audio Out
White Audio Out
Figure 3
1. Powering your DVD Player ( Refer to Figure 3)
Connect the black wire (-) to the vehicle ground. Connect the red
wire (+) to a switched (Accessory) 12VDC source. Plug the other
end into the 12VDC input jack on the back of the unit.
2. Remote IR Receiver ( Refer to Figure 3)
Plug the 1/8” plug on the remote IR cable into the IR IN jack on the
back of the DVD player. Place the IR receiver anywhere in the
vehicle to allow remote control from any location.
3. Connecting to a Monitor ( Refer to Figure 3)
a. Match the color-coded plugs to the appropriate jacks on the
back of the DVD Player A/V OUTPUT jacks: Yellow (video) to
Y ellow , White (left audio) to White, and Red (right audio) to Red.
8
Loading...