Audiovox ACA300T Users Manual

Wireless Transmitter and Receiver

Model:ACA300T
ACA300R

Installation Manual

Features:

• Operating frequency: 2.4GHz.

• Converts Hard Wired Systems to Wireless

• Developed for Backup Camera Systems

• RCA Connector

Warnings

The product is intended to assist in safe driving and to allow the driver to
have a broader rearview while the vehicle is in reverse. You, as the driver,
are solely responsible for the safe operation of your vehicle and the safety
of your passengers according to the country and their local traffic
regulations. Do not use any features of this system to the extent it distracts
you from safe driving. Your first priority while driving should always be
the safe operation of your vehicle. Audiovox Electronics Corporation
cannot accept any responsibility whatsoever for accidents resulting from
failure to observe these precautions or safety instructions.

1. This product utilizes high voltage. Any unauthorized modifications

or damage to the products may result in electrical shock. Handle
all components with care. Inspect regularly for damage to
components and cabling.

2. You shall be responsible to ensure that the installation of this

product does not void or affect the vehicle manufacturer’s
warranty. Audiovox Electronics Corporation or its subsidiaries are
not liable in full or in part for improper installation resulting in
loss or damage to your property, or for voiding all or part of the
vehicle manufacturer’s warranty.

3.

4.

Do not apply excessive force to any of the components contained
within this kit. Excessive force used before, during or after installation
that results in a damaged or non-functional part shall void all
warranties.

Please follow the procedure from this installation manual. Improper
installation or modification of this product shall void all warranties.

1

Table of Contents

Warnings 1
Table of contents 2
Product description 2
Packing list 2
Transmitter/Receiver installation 3
Specifications 4
Troubleshooting 5
FCC Statement 5

Product Description

The wireless transmitter and receiver have been developed to convert a
hard wire camera/monitor system to a wireless operation. The following
information contained in the installation manual is for camera backup
systems. Note: this product can be used on any Camera/Monitor system.

Packing List

1. Transmitter w/RCA Connector-1 qty

Transmitter/Receiver Installation

The transmitter and the receiver must be installed in the vehicle’s trunk or
interior. The transmitter and receiver are not weather proof and must be
located in a dry location

a) Wiring the transmitter to the vehicle reverse lamp. Using the

b) Black wire- Chassis/Ground. Using. Using the tap connectors

2. Wiring the transmitter to the camera.
a) Connect the transmitters RCA connector to the Cameras RCA

Tap/Run Connection

tap connectors supplied.

i. Place the unstripped positive lead wire on the run channel

ii. Insert the unstripped red power wire completely

iii. Fold the tap connector back over the wires and make the

connection by crimping the u-contact down flush with the
plastic insulator.

iv. Close the top hinged cover until latched.

supplied.

i. Place the unstripped ground lead wire on the run channel

ii. Insert the unstripped black ground power wire complete ly

iii. Fold the tap connector back over the wires and make the

connection by crimping the u-contact down flush with the
plastic insulator.

iv. Close the top hinged cover until latched.

connector.

2. Receiver w/RCA Connector-1 qty

3. Wire connectors:
a. Tap connectors-3 qty
b. Ring connectors-1 qty

4. Installation Manual

5. Warranty Card

2

3