Audiovox AABAT User Manual

11!8 tWo keydla/n hnsmitters that are.indtJded With this system are a

.~ 188m1ng ...type RadkJ Frequer'Cf transn1itfer. ...'."k:1 simply

nManS tJIat the srren control n'W)du1a ~111earn and remember the

~ ~e nllnber of 8ad1lransmitter .The siten oonIrcI module

~ leam d18 i..u.kluaJ =es of (2) ltai1SIniIIers ally .An .attempt to

.~.

program a thIrd -mitter WiD erase tf1e.~e number of the first

.,bIIISIr6r progr8I1med. .

~

~e tWo keychain transmitters that are.included With this system are a
.code learning. °type Radio Frequel1Cy bansniitfer, whk:h simply
means that the siren OJntrol fnodu~ \l,'ill Jeam and remember the

iOOIvidual code number of ead1 transmitter. The siten ccnIroI modu~ .

.~-

Wl1leam the individual ccxies of (2) ttai1Sii1itters OOIy. An. attempt to
program a third transmitter WIll erase the. cOOs number of the first

.,transmitter programmed. --° ° .

"

IMPaRT A~ .1 Save thess programming instructions in .a place where

you can easily find (hem in the fUture. Whenever the vehicl9's battery
is disconn~ed for ssrvicing,lhe transmitters will need to.b8 rep~

gf?tnmed. ...

To program the Transmitters; -.; ,

.A. The main hamGss ccnnGclai 5hQu:d be di5cooilOC{Gd from ult1 siren

.confrol m.odule at lhisStep of the installation procadure. It it is not,

.unofua the connednr

8. Be sUre to have both k,Qyd1ain transmitterS in hand, the'n plug the

main harness connector into the siren control nmule. You should

..~ .;

hear a short -chirp. from the siren. .:

c. Press and hold the largeram1i1ig D~,~9A1 Qf'Jrl{anslnitter number 1 until

the siren sounds one long. chirp D.lmmediatefy press and hold the Iarg~r hm1ing butt~ ~n..lranSII1itter

number 2 until the siren sOOnds one long. chirp E. 80 th Iransmi\t e r5' s ho u Id now be p rogramm ed. YoU Can t est th is by

..

pressing the arming button ~ eadt transmittei', \iI'f1k:h \ltiU result in
the awropriate .ARMED .or. DISARMeD -roofcation fran the Siren

.: .

module. IMP.oRtANT Ilf only one transmitter is operating, repeat ~ p~rarn-

ming proc:adure. Once the harness connector is plugged in, you have
only 15 seconds. in which to program both transmitters. This short time

winOOw is requir9:d in order to provide a high level of SSCtJrity.