Audiovox AA923, AA94BT User Manual

TRANSMITTER PROGRAMMING GUIDE

YOu NEED TO PROGRAM BOTH TRANSMITTERS AT THE SAME TIME

1. The main harness connector should be disconnected from the siren control module at this step of the installation procedure. If it is not, unplug the connector .

2. Be sure to have both keychain transmitters in hand, then plug the main harness connector into the siren control module. You should hear a short "chirp" from the siren.

3. Press and hold the arming button on the existing allready programmed transmitter until the siren sounds "one long "chirp".

4. Immediately press and hold the arming button on the second transmitter until the siren sounds one long "chirp".

5. Both transmitters should now be programmed. You can test this by pressing the arming button on each transmitter, which will result in

the appropriate " ARMED" or "DISARMED" indication from the siren.

IMPORT ANT! If only one transmitter is operating, repeat the programming procedure. Once the harness connector is plugged in, you

have only 15 seconds in which to program both transmitters. This short time window is required in order to provide a high level of security .

TRXPRG