Audiovox 811-870091-170 User Manual
Compact Disc Compact Player
Operating Instructions
Before operating the unit, please read this manual throughly and retain it for future reference.
WARNING : TO PREVENT FIRE OR SHOCK HAZARD, DO NOT
CAUTION
The use of optical instruments with this product will increase eye hazard.
INFORMATION (For the customers in USA)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following meaures :
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the euipment into an outlet that is on a circuit different from the one the receiver is connected.
- Consult the dealer or an experienced radio / TV technician for help.
You are cautioned that any changes or modifications not expressly approved in this manual could void
your authority to operate this equipment.
For the Customer in the United Kingdom and / European countries
This Compact Disc player is classified as a
CLASS 1 LASER product.
The CLASS LASER PRODUCT label is located
on the bottom exterior.
For the Customers in Canda
This apparatus complies with the Class B limits
for radio noise emissions set out in radio
interference regulations.
This product contains a low power laser device.
PRECAUTION
On safety
As the laser beam used in this compact disc player is harmful to the eyes, do not attempt to disassemble
the casing. Refer servicing to qualified personnel only.
Do not put any foreign objects in the safety slot inside the disc compartment. If you do so, the laser beam
may come out when the lid is opened.
Do not put any foreign objects in the DC in 6V (external power input) jack. Should any solid objects or
liquid fall into the unit, disconnect the power supply and have the unit checked by qualified personnel
before operating it any further.
On operation
Since the CD system offers a wide dynamic range, the peaks of the high level inputs are recorded with
high fidelity, and the noise level is very low. Do not turn up the volume while listening to a part of the disc
with no audio signals or very low level inputs. If you do, the speakers may be damaged when the peak
level of the sound is played. The lens on the disc table should be kept clean. Do not touch the lens or
poke at it. If you do, the lens may be damaged and the unit will ot operate properly.
EXPOSE THE UNIT TO RAIN OR MOISTURE.
TO AVOID ELECTRICAL SHOCK, DO NOT OPEN THE
CABINET.
REFER SERVICING TO QUALIFIED PERSONNEL ONLY.
CLASS 1 LASER PRODUCT
APPAREIL A LASER DE CLASSE 1
PRODUCTO LASER DE CLASE 1
PRODUTO LASER CLASSE 1
CAUTION
INVISIBLE LASER RADIATION
WHEN OPEN AND INTER
LOCKS DEFEATED.
AVOID EXPOSURE TO BEAM.
On installation
Never install the unit where it would be subjected to :
heat sources such as radiators or airducts
direct sunlight
excessive dust
mositure or rain
mechanical vibration or shock
unleved surface
• Do not place any heavy object on top of the unit.
• When the unit is used with an AC power adaptor, do not wrap the unit in a cloth, blanket, etc. If
you do, the temperature inside and outside the unit may rise considerably, resulting in
malfunctioning of the unit or serious accident.
• If the unit brought directly from a cold to warm location, or is placed in a very damp room, moisture
may condense on the lens inside the unit. Should this occur, the unit willl not operate. In this
case, remove the disc and leave the unit a warm place for several hours until the moisture
evaporates.
• For the unit to operate at its best, it should not be subjected to temperature below 5“C (41“F) or
above 35“C (95“F).
Notes on headphones / earphone
Do not use headphones / earphone while driving, cycling, or operating any motorized vehicle, it may
create a traffic hazard and is illegal in some areas. It can also be potentially dangerous to play your
headsets at high volume while walking, especially at pedestrian crossings. You should exercise extreme
caution or discontinue use in potentially hazardous situations.
Avoid using headphones / earphone at high volume. Hearing experts advise against continuous, loud
and extended play. If you experience a ringing in your ears, reduce volume or discontinue use.
Keep the volume at a moderate level. This will allow you to hear outside sounds and to be considerate to
the people around you.
If you have any questions or problems concerning your unit, please consult your nearest dealer.
POWER SOURCES
Using with batteries
Insert two size “AA” batteries (LR6 or SUM-3 alkaline) according to the “ 0 ” and “ 0 ” marks correctly
aligned.
Notes on batteries
• Insert batteries with correct polarity.
• Do not use old batteries together with new ones or different types of batteries together.
• If the electrolyte inside the battery should leak, wipe the contaminated parts in the battery compartment
with a cloth and replace the old batteries with new ones.
• When the unit is not to be used for a long period of time, remove the batteries.
• Do not mix old new batteries.
Do not mix ALKALINE, standard (CARBON-ZINC) or rechargeable (NICKEL-CADMIUM) batteries.
Notes on “ I—t ”
• During playback (batteries are in use), “ | [i ” is off.
• When the battery voltage level is low, “ | ii ” will light for approx. 10 ~ 15 minutes, playback still
continues in this period.
• Playback would automatically come to a stop when the batteries have no more power. Do not repeat
pressing “ [>[][] ” as the unit may operate incorrectly. Replace all the batteries with new ones.
• “ I ti ” would not be on if an AC adaptor is used.
Using on house current
If the unit you purchased does not include an AC power adaptor, please use a 6V 350mA AC power
adaptor. Plus pole “ 0 ” to the centre pin of the 3.5mm socket.
When the unit is not be used, be sure to disconnect the AC power adaptor.
FUNCTION OF CONTROLS
Opening the CD tray to
insert or remove a disc.
Ml
[>DD PLAY / PAUSE
Press [>[][] to begin play.
Press [>[][] during play to
pause.
To release pause, press □
again.
STOP □
Press once for disc playing
stops.
Press twice for power off.
Track search and fast
forward / fast reverse
- SKIP B«
Press [XKi lightly /
repeatedly :
To locate the beginning of
the current selection or
previous selections.
Keep [KjO depressed :
To go back at high speed
(search).
REPEAT
/Et^ER
PLAY
MODE
SKIP
+
Press [XX] lightly /
repeatedly :
To locate the beginning of
next selection / selections.
Keep [XX] depressed :
To go ahead at high speed
(search).
REPEAT / ENTER
Playing the selections in the
desired order.
PLAY MODE
Button for selecting the
various play mode.
Main socket
Phones jack
For connecting the
headphones / earphones.
VOL (Volume)
Adjust the volume.
DISC PLAYING
1. Open the CD tray with the “OPEN” button.
2. Insert the CD with the printed side facing upwards and push the disc gently unit it clicks so that the
disc fits into the pivot.
3. Press the CD door to close.
On display windows
When you press “ [>[][] ”, the display window shows :
Total number of tracks
During play
The track number of the current selection appears.
When “ Q ” is press during play, total number of tracks on the disc will be displayed and the unit still on.
If “ □ ” is pressed again the unit will be returned to full stop mode. If “ [>[][] ” is pressed the unit returns
to play mode. The unit will be returned to full stop mode automatically after approximately 35 seconds if
no button is played again within 35 seconds.
im is pressed once.
nc ».
U J ►
Track 5 is playing. DISC playing stops and total
During pause
The playing track number will flashes.
number of tracks is shown.
in
lU
First track playing begins
After approx. 35 sec.
Full stop mode.
n3v
UC t
When no disc is inserted onto the player and when “ [>[][] ” is pressed, the display window shows “ £r”.
The unit cannot be operated when error message is displayed. After approx. 35 seconds the unit will
return to full stop mode, or reset the player by pressing “ Q ” once and then insert a disc start playing.
Pause mode of the second track
VARIOUS PLAYING MODES
During playback, every time the “PLAY MODE” key is pressed, the mode would be changed to the next
one as follow :
NORMAL PLAY -> INTRO -> SINGLE MUSIC -> PROGRAM (PGM) -> RANDOM(RND)
*Repeat play of each mode is possible.
NORMAL PLAY - Playing the whole disc
There is no play mode indication in the display window. To repeat the
whole disc, press “REPEAT / ENTER”.
ПЗ .
uc ►
Play mode of the second track
PGM (Program) PLAY - Playing the selections in the desired order
1. Press “PLAY MODE” during play until “PGM” flashes in the display
,.nn
PGM
.
2. Press “ OOO ” or “ [>[;;:::{] ” to select the desired selection.
3. Press “REPEAT / ENTER” to register track no. 4 for example, as
the first selection. The track no. indication will be returned to “QQ
4. Repeat step 2 and 3.
-UU
,. nu
PGM
.-U I
MAINTENANCE
Cleaning the unit
Do not use volatile chemicals on this unit. Clean by lightly wiping with a soft cloth.
Cleaning CD
If the CD skips or will not play, the disc may need to be cleaned. Before playing, wipe the disc in a
circular motion from the centre out with a cleaning cloth. After playing, store the disc in its case.
Handing the disc
Only touch the CD on the edge to avoid finger prints on its surface. Do not stick paper or tape nor write
anything on the surface.
INTRO PLAY - Playing the first about ten seconds of all the selections
1. Press “PLAY MODE” during play until “ ^ ” disappears in the display
n I
и I
2. Press “PLAY MODE” to begin the “INTRO” play,
“ ^ "appears again in the display window.
3. Pressing “ [>[][] ” again will cease the “INTRO” play and continue
playback in the NORMAL play mode.
SINGLE MUSIC - Playing only one selection
1. Press “PLAY MODE” during play until the track number flashes.
2. Select desired track to be played only once by pressing ” or
3. To play only repeatedly, press “REPEAT / ENTER”.
n к
и !►
UC* ►
\ I /
/ I \
_n
N
и
/ 1
\ 1 /
_n
и
у I \
5. Press “ [>[][] ”, “PGM” stops flashing and program play starts.
* To repeat program play, press “REPEAT / ENTER”.
* If “ Q ” is pressed or if the lid as opened, all the programs would be cleared.
* If the program mode is exited by means of the “PLAY MODE” key, all the programs would still
remain in memory.
Program edition
To check : Press “REPEAT / ENTER” lightly during programming before you press “ [>[][] ”.
To change : When checking press either “ [}<}<] ” or “ [>[X] ” to alter track number for the program
To erase : When checking, if the track numer of a program is selected as “ QQ ”, all the
Each time “REPEAT / ENTER” is pressed the track number appears in the display
window.
currently displayed. Press “REPEAT / ENTER” to register the newly selected track
into memory.
subsequent programs starting from and including that program will be cancelled.
SHUFFLE PLAY - Playing the selections in random order
Press “PLAY MODE” until “
Random play starts from the next track, or when “ [>[][] ” is pressed.
Some swivelling symbols will be shown on the CD display and a short
period of time is needed for track shuffling.
To play the selections in random order repeatedly, press “REPEAT /
ENTER”. After every selection has been played in random order, they will be reshuffled and played
repeatedly in a different order each time.
* To locate the beginning of the track being played : press “ [KK] ”.
* To locate the next track : press “ [XX] ”. However, you cannot locate
a previous track even if you keep “ [KK] ” pressed.
” appears in the display windows.
RND
\
REPEAT PLAY - Playing the whole disc continuously
To repeat the whole disc, press “REPEAT / ENTER” will appear in the
display window.
PGM
RND
RND
RND
и
г n
np^
uo^
nc^
TROUBLE SHOOTING GUIDE
Should and problem persist after you have made the following checks, consult your nearest service
facility.
Disc play does not start :
The disc is inserted upside down or incorrectly. Insert the disc correctly with the label surface up
Dusty or defective disc
Dirty or dusty lens
The disc compartment lid is not close.
Moisture condensation -> Leave the unit in a warm place until the moisture evaporates
The AC power adaptor is not plugged into the wall outlet
The unit is not placed on a level surface
Weak batteries
No sound from the headsets :
• The headphones / earphone plug is not firmly connected to the “PHONES” jack
• Adjust the “VOL” control
• Dirty plug
No sound from the connected speakers :
• Check the connections
• The amplifier is not turned on
Skipping of sound :
• Dirty or defective disc
• Dirty lens
• Strong vibration
When using with batteries the battery life is short :
• Manganese batteries are used. Use alkaline batteries.
Display windows shows “ ” error message and the unit cannot be
operated :
• No disc, dirty disc or scratched disc. The unit will return to full stop mode after approx. 30 seconds, or
reset the player by pressing “ □ ” once and then insert a disc to start playing.
и J ►
SPECIFICATIONS
General
Output (at 1KHz 0db level) Headphones / earphone (stereo minijack)
Power requirements
Dimensions
Weight
Operating voltage 120V AC ± 5% 60 Hz
Design and specifications are subjest to change witout notice.
PRINTED IN CHINA 811-870091-170
15 mW + 15mW at 16W to 32W
2 size “AA" (LR6 or SUM-3) alkaline batteries; or DC in 6V, 350mA power
adaptor
Polarity of plug
Approx. 129 x 30 x 142mm (W/H/D)
Approx. 225g (not include batteries)
U.S.A., CANADA
MIDDLE EAST and AUSTRALIA
UK and GERMANY
CHILE
SINGAPORE, MALAYSIA & THAILAND
JAPAN
240V AC ± 5% 50 Hz
230V AC ± 5% 50 Hz
230V AC ± 5% 50 Hz
200 - 240V AC ± 5% 50 Hz
100V AC ± 5% 50/60 Hz
Loading...