Audiovox 5125 User Manual
Model 091BPr
Transmitter Programming Guide
This transmitter is designed for use with your upgrade
remote start unit and is programmed by using the remote
start's program switch in combination with the transmitter
button. Although this transmitter can be programmed into
any of the Audiovox remote start and or alarm, remote start
systems, it will offer limited use and should be used for the
remote start upgrade only.
To program this transmitter into your remote start upgrade
unit:
1) Turn the ignition to the on position
2) Press and release the programming switch 3 times
3) Press and hold, for 3 seconds, the button of the transmitÂter you wish to add until the parking light flashes indicating
the transmitter has been learned.
4) Repeat step 3 for each transmitter up to a total of 4.
Turn the ignition off to exit the program mode.
NOTE: Do not allow more than 15 seconds to lapse between
steps or the program mode will be automatically exited and
you will have to start over.
1
128-8707
1 of 2
After removing the two #0 point
phillips screws shown, pry
apart case with the edge of a
finger nail or a small common
screwdriver. Keep hold of the
metal key ring loop to prevent it's
loss as it will separate from the
transmitter case.
Carefully remove the
discharged battery by sliding it
out from under the clip in the
direction indicated by the arrow
in the diagram. Properly dispose
of the exhausted battery and
insert a new CR2032 taking
care to arrange it so that the +
is facing up toward the +
symbol on the battery clip.
Reassemble in the reverse of
above.
This device complies with FCC Rules Part 15 Operation is
subject to the following two conditions.
(1) This device may not cause harmful interference and
(2) This device must accept any interference that may be
received, including interference that may cause undesired
operation.
NOTE: The manufacturer is not responsible for any radio or
TV interference caused by unauthorized modifications to
this equipment. Such modifications could void the user’s
authority to operate the equipment
2
128-8707
2 of 2
Loading...