Audio Technica BM03R8645 User Manual

BM03R8645

BM03R8645BM03R8645

Manual

ManualManual

Since this device is always used with Audio-Technica Wireless Device, it is not sold to general

end users separately.

Therefore there is no user manual of this device by alone.

And this device will install on Audio-Technica development products only. The following

statements must be described on the user manual of the Audio-Technica Wireless Device;

Important notice

For use in the United States. 1

Module User Requirements

FCC 15.212(a)(ⅵ)(A)

The host device must contain the following permanent labeling on the exterior of the

host device as follows:

Contains FCC ID: ○○○○○△△△△△△△

FCC 15.19(a)(3)

The host device shall bear the following statement in a conspicuous location on the

device:

This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received,including interference that may cause undesired

operation.

When the device is so small or for such use that it is not practicable to place the

．

statement specified under paragraph 15.19(a)(3) of this section on it, the information

required by this paragraph shall be placed in a prominent location in the instruction

manual or pamphlet supplied to the user or, alternatively,shall be placed on the

container in which the device is marketed.

2． The user manual of the host device must contain the following paragraph:

FCC 15.21

Caution: Changes or modifications not expressly approved by the party responsible

for compliance could void the user’s authority to operate the equipment.

FCC15.105(b)

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential

installation. This equipment generates, uses and can radiate radio frequency

energy and,if not installed and used in accordance with the instructions, may cause

harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

IMPORTANT NOTE:

ⅰ

.That module is limited to OEM installation only.

ⅱ

.That OEM integrators is responsible for ensuring that the end-user has no manual

instructions to remove or install module.

ⅲ

.That module is limited to installation in mobile or fixed applications, according to

Part 2.1091(b)

ⅳ

.That separate approval is required for all other operating configurations,

Manual Information to the End User

The OEM integrator has to be aware not to provide information to the end user

regarding how to install or remove this RF module in the user’s manual of the end

product which integrates this module. The end user manual shall include required

regulatory information/warning as below.

ⅰ

.End-users must be provided with transmitter/antenna installation requirements

and operating conditions for satisfying RF exposure compliance.

ⅱ

.A separate section should clearly state “FCC RF Exposure requirements:”

ⅲ

.Required operating conditions for end users

+ 4 hidden pages