Audio-Technica ATW-RM1 User manual

Professional UHF Wireless Systems

ATW-RM1 Rack Mount Hardware Kit

Installation and Operation

Assembly Instructions/ATW-RM1 Rack-mount Hardware Kit

For use with Audio-Technica 2000 and 3000 Series wireless systems and for the ATW-DA49 antenna distribution system.

This kit contains the hardware necessary for mounting a half-rack receiver or distribution system in a 19" audio equipment rack; also brings antennas to the front for improved reception.

The following parts are included:

• Long rack ear

• Short rack ear

• Two BNC bulkhead connectors with mounting hardware

• Two 34" BNC-to-BNC cables

• Six rack ear screws

Figure 1

How to assemble the ATW-RM1 Rack Mount Hardware Kit (see Fig. 1)

1. Remove the nut and lock-washer from each bulkhead connector. Install the connectors from the front into the two holes in the long rack ear (see Fig. 1). Note that the flat on the threaded section must be aligned with the flat in each panel hole.

2. Install the lock-washer and nuts (included) over the back of each bulkhead connector. Secure each connector from the back with its lock-washer and nut, tightening the nut firmly.

3. Connect one end of each provided BNC-BNC cable to the rear antenna input jacks on the back of the receiver (or antenna distribution system amplifier). Attach the other end of each cable to the back of the BNC bulkhead connectors. Make certain the bayonet twist-rings are fully latched on the connectors at both ends.

4. Finally, mount the receiver's antennas to each of the BNC bulkhead connectors.

BNC-BNC Cables

Long Rack Ear

Nut

Lock-Washer

Rubber Washer

Bulkhead Connector

Short Rack Ear

Antennas (not included)

One-Year Limited Warranty

Audio-Technica brand products purchased in the U.S.A. are warranted for one year from date of purchase by Audio-Technica U.S., Inc. ( A.T.U.S.) to be free of defects in materials and workmanship. In event of such defect, product will be repaired promptly without charge or, at our option, replaced with a new product of equal or superior value if delivered to A.T.U.S. or an Authorized Service Center, prepaid, together with the sales slip or other proof of purchase date. abuse, shipping damage, or failure to use product in accordance with instructions. This warranty is void in the event of unauthorized repair or modification, or removal or defacing of the product labeling.

For return approval and shipping information, contact the Service Dept., Audio-Technica U.S., Inc., 1221 Commerce Drive, Stow, Ohio 44224.

Except to the extent precluded by applicable state law,

warranty of merchantability or fitness for particular purpose expires when this warranty expires.

This warranty gives you specific legal rights, and you may have other rights which vary from state to state.

Outside the U.S.A., please contact your local dealer for warranty details.

Audio-Technica U.S., Inc., 1221 Commerce Drive, Stow, Ohio 44224 330/686-2600 www.audio-technica.com

Audio-Technica Limited, Old Lane, Leeds LS11 8AG England 0113 277 1441 www.audio-technica.co.uk

Prior approval from A.T.U.S. is required for return. This warranty excludes defects due to normal wear,

A.T.U.S. will have no liability for any consequential, incidental, or special damages; any