
PANTHER
ANALOG AUDIO INTERCONNECT
3 x 21 AWG Solid PePerfect-Surfacerfect-Surface Copper Copper++
(PSC+) Conductors
Solid Perfect-Surface
Copper+ (PSC+)
Teflon
Air Tubes
DBS Anode
(+36V)
Welded,
Direct Silver-Plating,FPC
Silver-Plated Drainwire
PSC+ CONDUCTORS: Solid conductors prevent strand interaction, a major source of cable distortion.
Extremely high-purity Perfect-Surface Copper+ (PSC+) minimizes distortion caused by grain boundaries
which exist within any metal conductor, nearly eliminating harshness and greatly increasing clarity
compared to OFHC, OCC, 8N and other coppers.
TEFLON AIR-TUBES: Air is the best insulation because it does not absorb and later release energy. The
Teflon Air-Tubes used in Panther have almost nothing but air around the PSC+ conductors.
Teflon Air-Tube InsulationTeflon Air-Tube Insulation
DBS AnodeDBS Anode (+)
DBS CathodeDBS Cathode (-) 22 AWG Solid Silver-Plated
Drainwire + Foil Shield
36V DBS Battery Pack36V DBS Battery Pack Included
DIELECTRIC-BIAS SYSTEM (patent pending): Greatly improved performance is made possible by a
constant 36 volt charge on all Panther’s insulation. As 36 volts is far above the voltage of an audio signal,
the result is considerably more transparency and dynamics than possible even from a cable in continuous
use, with equipment that is never turned off. Because DBS battery packs are attached when Panther cables
are assembled, Panther does not require an additional run-in period. Because there is no “load” on the
single standard hardware-store battery, it will last for years. A test button and LED allow for occasional
verification of battery performance.
TRIPLE BALANCED: The 3 conductors in "Triple Balanced" Panther cable insure that whether prepared
with RCA or XLR plugs, the positive and negative signals have equally low distortion conducting paths. The
100% coverage shield is never used as an inferior audio conductor.
WELDED PLUGS: 8,000 amps is used to weld FPC Copper RCA plugs to Panther, creating a perfect connection
alloy where the cable and plug meet. A thick direct-silver plating provides the best possible connection.