Audionet AMP II Owner's Manual

Audionet

AMP II

Mono - Amplifier

Owner's Manual

Owner's manual

The Audionet-Team would like to congratulate you to purchasing the
Audionet AMP II! Your Audionet AMP II is designed for absolutely
natural music reproduction at highest user comfort embedding total sys­tem security.

Please read this manual before first use to make sure that you are able to
use all provided functions of your new amplifier.

In case of questions to occur please do not hesitate to contact your local
Audionet dealer or our factory directly.

2

Setting up your system

Placing

Power connections

Polarization

Your Audionet AMP II have the perfect dimensions to be placed near
your speakers. But put side by side both AMP II are 43 cm in width
(standard width).

Do not cover the top to prevent the amplifiers from overheating!

Please connect the power jack at the rear to your wall outlet using a suit­able power cord. Using high quality power cords may increase sound
quality. Please consult you local Audionet dealer.

The voltage specified at the rear of your AMP II must match your mains
specifications. The AMP II is a Class I unit and has to be earthed.

The correct polarization of mains is important for reasons of audio clarity
and stability. Please make sure that the "hot" pin of your power cord is
connected to the left pin of the power jack (front view).

3

Inputs and outputs

For connecting or removing any units the AMP II must be switched off.

Please make sure that all cables are in absolute best condition. Broken
shields or short-cut loudspeaker cables could damage loudspeakers or
the amplifiers!

Inputs

Speakers

At first please connect your pre amplifier to the inputs of your AMP II.
For audio input you can use balanced (XLR) as well as unbalanced
(cinch) cables. For connections longer than 2 m we recommend balanced
cables.

Please don't forget to activate the selected input in the set menu.

Now connect your speakers to one pair of the gold plated output jacks of
your AMP II. You may use pure wires or "banana" plugs.

Check the polarization of the speakers cables:

Usually the speaker jacks are labeled "+" and "-". You will find the same
label at your AMP II.

Wrong polarization will lead to severe loss of sound quality!

The speaker impedance must not be less than 2W!

Though your AMP II is effectively protected against shorted speaker
jacks it has to be switched off while working on speakers and speaker
cables!

Bi-Wiring

Your Audionet AMP II supports bi-wiring of loudspeakers. Connect your
speaker with two separate cables to each AMP II. Using the bi-wiring
method to connect your speakers can lead to enhanced sound quality.

4