Audionet AMP-2-MAX Owners manual

audionet

amP II max

Mono - Amplifier

Owner's Manual

Owner's manual

The Audionet-Team would like to congratulate you to purchasing the
Audionet AMP II MAX! Your Audionet AMP II MAX is designed for
absolutely natural music reproduction at highest user comfort embedding
total system security.

Please read this manual before first use to make sure that you are able to
use all provided functions of your new amplifier.

In case of questions to occur please do not hesitate to contact your local
Audionet dealer or our factory directly.

2

Setting up your system

Placing

Power connections

Mains phase recognition

Your Audionet AMP II MAX have the perfect dimensions to be placed
near your speakers. But put side by side both AMP II MAX are 43 cm in
width (standard width).

Do not cover the top to prevent the amplifiers from overheating!

Please connect the power jack at the rear to your wall outlet using the
provided Audionet Power Cord (APC).

The voltage specified at the rear of your AMP II MAX must match your
mains specifications. The AMP II MAX is a Class I unit and has to be
earthed.

The correct polarization of mains is important for reasons of audio clarity
and stability. Please make sure that the pin labled "Phase" at your APC is

connected to the "hot" pin of your wall outlet. The Audionet AMP II
MAX indicates a wrong polarization of the mains lead. If you read: ” At-
tention: Mains Phase incorrect” when powering up, switch
off the AMP II MAX and flip the plug in your wall outlet.

3

Inputs and outputs

For connecting or removing any units the AMP II MAX must be switched
off.

Please make sure that all cables are in absolute best condition. Broken
shields or short-cut loudspeaker cables could damage loudspeakers or
the amplifiers!

Inputs

Speakers

At first please connect your pre amplifier to the inputs of your AMP II
MAX. For audio input you can use balanced (XLR) as well as unbalanced
(cinch) cables. For connections longer than 10 m we recommend balanced
cables.

Please don't forget to activate the selected input in the set menu.

Now connect your speakers to one pair of the gold plated output jacks of
your AMP II MAX. You may use pure wires or "banana" plugs.

Check the polarization of the speakers cables:

Usually the speaker jacks are labeled "+" and "-". You will find the same
label at your AMP II MAX.

Wrong polarization will lead to severe loss of sound quality!

The speaker impedance must not be less than 4W!

Though your AMP II MAX is effectively protected against shorted
speaker jacks it has to be switched off while working on speakers and
speaker cables!

Bi-Wiring

Your Audionet AMP II MAX supports bi-wiring of loudspeakers. Con­nect your speaker with two separate cables to each AMP II MAX. Using
the bi-wiring method to connect your speakers can lead to enhanced
sound quality.

4