Audionet AMP-2-G-3 Owners manual
audionet
amP II G2
Mono - Amplifier
Owner's Manual
Owner's manual
The Audionet-Team would like to congratulate you to purchasing the
Audionet AMP II G2! Your Audionet AMP II G2 is designed for absolutely natural music reproduction at highest user comfort embedding total
system security.
Please read this manual before first use to make sure that you are able to
use all provided functions of your new amplifier.
In case of occuring questions please do not hesitate to contact your local
Audionet dealer or our factory directly.
2
Setting up your system
Placing
Power connections
Mains phase recognition
Your Audionet AMP II G2 have the perfect dimensions to be placed near
your speakers. But positioned side by side both AMP II G2 are 43 cm in
width (standard width).
Do not cover the top to prevent the amplifiers from overheating!
Please connect the power jack at the rear to your wall outlet using a suitable power cord. Using high quality power cords may increase sound
quality. Please consult you local Audionet dealer.
The voltage specified at the rear of your AMP II G2 must match your
mains specifications. The AMP II G2 is a Class I unit and has to be
earthed.
The correct polarization of mains is important for reasons of audio clarity
and stability. Please make sure that the pin labled "Phase" at your APC is
connected to the "hot" pin of your wall outlet. The Audionet AMP II G2
indicates a wrong polarization of the mains lead. If you read: ”Atten-
tion: Mains Phase incorrect” when powering up, switch off
the AMP II G2 and flip the plug in your wall outlet.
3
Inputs and outputs
For connecting or removing any units the AMP II G2 must be switched
off.
Please make sure that all cables are in absolute best condition. Broken
shields or short-cut loudspeaker cables could damage loudspeakers or
the amplifiers!
Inputs
Speakers
At first please connect your pre amplifier to the inputs of your AMP II
G2. For audio input you can use balanced (XLR) as well as unbalanced
(cinch) cables. For connections longer than 10 m we recommend balanced cables.
Please don't forget to activate the selected input in the set menu.
Now connect your speakers to one pair of the gold plated output jacks of
your AMP II G2. You may use pure wires or "banana" plugs.
Check the polarization of the speakers cables:
Usually the speaker jacks are labeled "+" and "-". You will find the same
label at your AMP II G2.
Wrong polarization will lead to severe loss of sound quality!
The speaker impedance must not be less than 2W!
Though your AMP II G2 is effectively protected against shorted speaker
jacks it has to be switched off while working on speakers and speaker
cables!
Bi-Wiring
Your Audionet AMP II G2 supports bi-wiring of loudspeakers. Connect
your speaker with two separate cables to each AMP II G2. Using the biwiring method to connect your speakers can lead to enhanced sound quality.
4
Loading...