Audionet AMP-1 Mk2 Owners manual
Stereo - Amplifier
Owner's Manual
How to operate the Audionet AMP I V2
The Audionet AMP I V2 is an audio power amplifier of highest performance and finish quality and long-life stability. This system is designed
for absolute natural music reproduction.
The following will give you all information about how to operate your
AMP I V2. Please read this carefully before the first use. Following these
instructions, your AMP I V2 will give you long-lasting pleasure and satisfaction.
2
Connecting the system
Power supply
Inputs
Please connect the power jack at the rear to your wall outlet. You should
either use the provided power cord or another one allowed for your
homecountry specifications.
NOTE:
The power specifications on the rear must meet to your home country specifications.
The AMP I V2 is a Class I-system and must be earthed. Please ensure a stable earth connection.
For connecting or removing a preamplifier, the AMP I V2 has to be
switched off. Please ensure that all connector cables are in absolutely
best condition.
The AMP I V2 has two RCA inputs for the connection of a preamplifier,
e.g. Audionet PRE. Due to the dual mono construction, left and right
inputs are separated at the rear.
Outputs / Loudspeakers
Please connect left and right input of the AMP I V2 to the corresponding
outputs of your preamplifier.
The AMP I V2 has a protection circuit to prevent damage of the system
in case of short-circuit between the loudspeaker outputs. Nevertheless, to
be on the safe side your AMP I V2 should be switched off while you are
working on the cables between amplifier and loudspeakers.
Please connect the left and right loudspeaker outputs to the corresponding inputs of your loudspeakers. You should pay attention to phase coincidence of your connections. This means that the red outputs (+) of the
amplifier are connected to the positive inputs of the loudspeakers (usually red) and the white outputs (-) are connected to the loudspeakers’
3
Loading...