Audioline Millennium User Manual

MILLENNIUM

Telephone

CONNECTING

# Connect the line cord to the wall socket and the underside of the telephone.
# Connect the handset curly cord to the left hand side of the telephone.
# Lift the handset and check for dial tone.

TO CALL

# Lift the handset and wait for dial tone.
# Dial the phone number.
# Finish the call by replacing the handset.

ADJUSTABLE RINGER

This telephone has programmable ringer selection. You can select between three
levels of three types of ring signal plus ringer off.

P Ensure the switch on the underside of the telephone is set to Programming.
P Lift the handset (ignore network tones) and press the redial button.
P Press [#] key.
P Select ring signal by pressing 0 - 9 according to the table below.
P Press redial button again.
P Replace the handset, the ring signal is now selected.
P Set the switch on the bottom to Telephone.

Key/setting Melody type Ringer level

1 Melody A Low
2 Melody A Normal
3 Melody A High
4 Melody B Low
5 Melody B Normal
6 (default setting) Melody B High
7 Melody C Low
8 Melody C Normal
9 Melody C High
0 Off * -

* If setting 0 is selected, the ring signal will be turned off until the handset is lifted

again. After that, the ring signal reverts to the previous setting.

NOTE: The normal ringer is an internal electronic ring. The two external bells will

only ring when you turn the handle.

1