Audio Authority 1185ci User Manual

User Manual

Model 1185ci

HDTV Signal Distribution Amplier

3

Model 1185ci

HDTV Signal Distribution Amplier

Table Of Contents

1.0 Introduction . . . . . . . . . . . . . . . . . . . . . . . 2

1.1 Liability Statement . . . . . . . . . . . . . . . . . . . 3

3.0 Checking Package Contents . . . . . . . . . . . . . . . 3

4.0 Installation . . . . . . . . . . . . . . . . . . . . . . . . 5

5.0 Troubleshooting . . . . . . . . . . . . . . . . . . . . . 5

6.0 Limited Warranty . . . . . . . . . . . . . . . . . . . . 6

7.0 Specications . . . . . . . . . . . . . . . . . . . . . . 7

8.0 Regulatory Compliance . . . . . . . . . . . . . . . . . 7

9.0 Contact Information . . . . . . . . . . . . . . . . . . . 8

1.0 INTRODUCTION

Thanks for purchasing this Model 1185ci Signal Distribution
Amplier from Audio Authority. This product is designed to allow
audio and high denition video signals to be distributed to a total
of four destinations, without signal degradation. The Model 1185ci
is the rst Audio Authority distribution amp expressly designed
for Custom Installers of Home Theater systems. It includes the
most-asked-for features, such as ultrawide video bandwidth, audio
channels that also pass sync for RGBHV displays, and full optical/
coaxial support of digital audio with automatic conversion. Housed
in a durable steel enclosure, the Model 1185ci also has side-looking
input and output jacks for extra compact cable routing. Audio
Authority also offers an extensive line of audio and video switchers,
converters, and distribution amps available for purchase online at
www.audioauthority.com or through authorized dealers.

2

1.1 Liability Statement

Every effort has been made to ensure that this product is free of
errors. Audio Authority cannot be held liable for the use of this
hardware or any direct or indirect consequential damages arising
from its use. It is the responsibility of the user of the product to
check that it is suitable for his/her requirements and that it is
installed correctly. All rights reserved. No parts of this manual may
be reproduced or transmitted by any form or means electronic
or mechanical, including photocopying, recording, or by any
information storage or retrieval system without the written consent
of the publisher.

Audio Authority reserves the right to revise any of its hardware and
software following its policy to modify and/or improve its products
where necessary or desirable.

Audio Authority and the Double-A Symbol are registered trademarks
of Audio Authority Corp. Copyright April, 2006, all rights reserved.
All third party trademarks and copyrights are recognized.

1.2 FEATURES

• Ultra-high bandwidth

• Supports 480i, 480p, 720p, 1080i, 1080p and other resolutions

• One input, four outputs

• Component video with stereo audio or RGBHV

• Rugged all-metal construction

• Compact form factor: 1.75 x 10.5 x 4.1 (HxWxD, inches)

3.0 CHECKING PACKAGE CONTENTS

Before attempting to use this unit, please check the packaging and
make certain the following items are contained in the shipping
carton:

• 1185ci Distribution Amplier

• 12V DC Power Adapter

• User Manual

Note: Please retain the original packing material should the need ever arise

to return the unit. If you nd any items are missing, contact Audio Authority
immediately. Have the Model Number, Serial Number, and Invoice available for
reference when you call.

3

5

12V DC

POWER

4

COAX

DIGITAL

AUDIO

OPTICAL

L R

PrPbYVIDEO

COAX

DIGITAL

AUDIO

OPTICAL

L R

PrPb

YVIDEO

3

COAX

DIGITAL

AUDIO

OPTICAL

L R

PrPb

YVIDEO

2

Made in USA • Audio Authority, Lexington, Kentucky

800-322-8346 • 859-233-4599 • www.audioauthority.com

RGB

/ YPbPr

COAX

DIGITAL

AUDIO

OPTICAL

L R

PrPbYVIDEO

1

COAX

DIGITAL

AUDIO

OPTICAL

L R

PrPbYVIDEO

INPUT

MODE

SWITCH

ANALOG AUDIO

INPUT JACKS

-OR-

H AND V SYNC

WHEN IN RGB MODE

-OR-

RGB* (GREEN, BLUE, AND RED)

COMPONENT VIDEO (Y, Pb, AND Pr)

POWER

INDICATOR

DIGITAL

AUDIO

POWER

CONNECTION

4

* IN RGB mode, be sure to connect H and V to the analog left and right audio jacks.

4.0 INSTALLATION

Connect the input port to a source of Component or RGB video
using high-quality patch cables. Connect each of the four outputs to
its destination television using coaxial cable suitable for baseband
video, such as RG-59 with a solid copper center conductor. Do not use
RG-6 or steel-core cable. Plug the included 12 volt DC power supply
into the Model 1185ci Power jack and plug the wall adapter into an
AC outlet.

4.1 VIDEO APPLICATIONS

The 1185ci may be used for either YPbPr or RGBHV video. When
using component video, set the mode switch to YPbPr and connect
audio and video cables as indicated on the panel legends. In RGB
applications, set the switch accordingly and connect the red green
and blue video cables acording to the jack color code, and connect
the horizontal and vertical sync to the wideband L and R audio jacks.
As a result, only digital audio pathways are available when using
RGB mode.

5.0 TROUBLESHOOTING

• Ground loops often cause disturbances such as hum in the audio
channels, rolling bars in the picture, or jitter in RGBHV video. In
the event a ground loop interferes with downstream television
performance, add an Audio Authority Model 1184 Hum Eliminator
at each television that exhibits the symptoms.

• Make certain that the Distribution Amplier is receiving power by
looking at the power LED. If the DA is not receiving power, check
the AC outlet or suspect the power supply.

• In RGB applications, be sure all ve video cables are connected
– RGB requires separate cables to pass H and V (horizontal and
vertical sync) in addition to the cables for red, green, and blue.
Connect the H and V cables to the R and L audio jacks.

If the problem still persists after trying the above suggestions,
contact the Audio Authority Technical Service department via email:
[e-mail], or call 800-322-8346 or 859-233-4599.

6.0 LIMITED WARRANTY

Should any consumer use product from Audio Authority fail due to
defects in materials or workmanship within one year from the date
of the original sale to the end-user, Audio Authority guarantees that

5

7

we will replace the defective product at no cost. Freight charges for
the replacement unit will be paid by Audio Authority (ground service
only). A copy of the invoice showing the item number and date of
purchase (proof-of-purchase) must be submitted with the defective
unit to constitute a valid in-warranty claim.

Units that fail after the warranty period has expired may be returned
to the factory for repair at a nominal charge, if not damaged beyond
the point of repair. All freight charges for out-of-warranty returns
for repair are the responsibility of the customer. Units returned for
repair must have a Return Authorization Number assigned by the
factory.

This is a limited warranty and is not applicable for products which,
in our opinion, have been damaged, altered, abused, misused, or
improperly installed. Audio Authority makes no other warranties
either expressed or implied, including limitation warranties as to
merchantability or tness for a particular purpose. Additionally,
there are no allowances or credits available for service work or
installation performed in the eld by the end user.

6.1 WARRANTY SERVICE PROCEDURES

If you suspect a product defect, contact Audio Authority’s Technical
Service Department at 800-322-8346 or 859-233-4599 for assistance in
verifying the problem. If a defect or potential defect is suspected, a
replacement unit will be shipped immediately on a defect-exchange
basis and a Return Authorization Number will be issued for the
return of the defective product. Replacement units are sent out at
the Manufacturer’s Suggested Retail Price which is debited to the
Customer’s Credit Card at the time of shipment. Once we receive
the defective unit back at the factory, it will be evaluated under the
conditions of this warranty and if found to be in-warranty, a full
credit will be issued to the Customer’s Credit Card. Return freight
charges for the defective unit are the customer’s responsibility.
Please contact our Technical Service Department for complete details
concerning all in and out of warranty service matters.

We appreciate your condence in our products and services and will
always strive to meet or exceed your needs.

6

7.0 SPECIFICATIONS

Video Parameters

Signal Type Component/RGBHV

Video Resolutions Supported All, including 480i/p, 720p, 1080i/p

Input/Output Impedance 75 ohms

Input Ground Isolation No

Gain Unity gain (1-to-1)

Gain Accuracy 1%

3dB Bandwidth 250MHz

Input Coupling AC/sync tip clamped

S/N Ratio 65dB

Max Gain/Equalization 1

Audio Parameters

Analog/Digital Digital/Analog

Digital Input/Output Type Optical+Coaxial In/Out

Input Impedance 75 ohms/10K ohms

Min Load Impedance 75 ohms/10K ohms

Multi-channel Digital Yes

Frequency Response DC-1MHz

S/N Ratio 72dB

THD+Noise 0.05%

Crosstalk 62dB

DC Input Connector 5.5 X 2.1mm

DC Input Voltage/Polarity 12V/Center positive

Max DC Input Current 180mA

Power Supply 571-013

8.0 REGULATORY COMPLIANCE

The Power Adaptor/Supply included with this unit has been tested
for compliance with UL, CE, and CSA rules and regulations and is
RoHS compliant.

7

9.0 CONTACT INFORMATION

If you have questions or require assistance with this product in areas
not covered by this manual, please contact Audio Authority using the
information below.

Audio Authority Technical Service
800-322-8346 M-F 8:30 AM to 5:00 PM, EST
International: 859-233-4599 Fax: [phone]
Send email to: [e-mail]

Audio Authority Corporation
2048 Mercer Road
Lexington, Kentucky 40511-1071
USA

2048 Mercer Road, Lexington, Kentucky 40511-1071

Phone: [phone] • Fax: [phone]

Customer Toll-Free USA & Canada: 800/322-8346

Website: http://www.audioauthority.com

752-545

6/07