atwood Levelegs System Adapter Kit User Manual

LITERATURE NUMBER

LEVELEGS™ SYSTEM

MPD 61050

ADAPTER KIT

•Installation •Operation •Maintenance

ENGLISH, FRANÇAIS (et Canada) Effective 12/12/07

24 HOUR TROUBLESHOOTING HELP CALL - 800-884-7012

Provided by Coach Net®, the largest RV owner support company in North America.

SAFETY ALERT SYMBOLS

Safety Symbols alerting you to potential personal safety hazards. Obey all safety messages following these symbols.

Figure 1

 WARNING  CAUTION

avoid possible avoid possible injury or death injury and/or property damage

FOR YOUR SAFETY READ ALL INSTRUCTIONS

BEFORE INSTALLATION AND OPERATION

Installer: Provide these instructions to the consumer. Consumer: Keep documents for future reference.

Atwood Levelegs™ Levelers are intended for use on recreation vehicle motorhomes and trailers.

 WARNING

VEHICLE CAN MOVE OR COLLAPSE

• Never exceed the rated capacity of the leveler as stated on its label.

• Levelers are not designed to be used as jacks. Do not use levelers to

lift the vehicle during tire changes, axle work or other servicing. The tires must stay on the ground.

Figure 2

INSTALLATION

LEVELER LEG

1. Prior to installation, retract the levelers so the foot pads are within 1/2˝ to 1˝ from the end of the outer housing (FIG 1-A).

2. Remove Round Tube Leveleg.

3. Attach new Frame Bracket ( (FIG 2-B), using hardware kit provided. Depending on the model use four (4) to six (6) each 1/2 - 13 Grade 5 bolts and nuts and 12 of the 1/2˝ Type A washer.

4. Position leveler vertically against frame so base of foot has 8-9˝ minimum ground clearance when vehicle is loaded to its maximum

FIG 1-B).

GVWR (

5. Fit the Leveleg bracket (FIG 2-C) around the Leveleg, (FIG 2-D) engaging one tab in the slot of the bracket ( (FIG 2-E & F) below the bracket (FIG 2). Bracket may be rotated 180˚ for more/less ground clearance and either set of mounting holes may be used. Attach the Leveleg bracket to the frame bracket with 1/2˝ - 13 grade 5 bolts and 1/2˝ flat washers on the Leveleg bracket and a 1/2˝ flat washer, 1/2˝ locking washer and 1/2˝ - 13 grade 5 nut. To install on 5th wheel trailers, refer to MPD 71125.

Lubricate the bolts and torque to 65 ft-lbs. Insure the top two and

bottom two holes in leveler brackets have bolts in them.

ELECTRICAL CONNECTIONS

1. Check the existing old round tube leveler.

ONE (1) PLUG ON WIRES COMING FROM THE MOTOR - Wiring Harness supplied

in this kit is not

(2) PLUGS ON WIRES COMING FROM THE MOTOR - Find the wires from the

TWO

motorhome signal wire harness that were attached to the round tube leveler. Connect those two wires to the two plugs from the ‘Y’ wire harness (FIG 3-A).

required.

FIG 2-A) to existing location on frame

FIG 2) and the other tab

Figure 3