Atrix VACO22VDC, PMP22VDC User Manual

OMEGA CORDLESS SERIES VACUUM

INSTRUCTION MANUAL

Model: VACO22VDC, PMP22VDC

Atrix

1350 Larc Industrial Blvd.

Burnsville, MN 55337

www.atrix.com

[e-mail]

Telephone: [phone]

Toll Free Telephone: [phone]

Fax: [phone]

Omega Cordless Series Vacuum Instruction Manual

For Models: VACO22VDC, PMP22VDC

Per CFR 49, Lithium Ion batteries may be considered “hazardous goods.” As
such, they are subject to SPECIAL handling and/or packaging regulations for
ground and air shipping.

Proper shipping procedures compliant with CFR 49 MUST BE FOLLOWED.

IMPORTANT SAFETY INSTRUCTIONS

When using your Vacuum, basic safety precautions should always be

observed, including the following:

Vacuum Safety

Read Owner’s Manual before using this product.

Failure to do so can result in serious injury or death.

1. Use only as described in this manual. Use only the recommended attachments,
battery, charger, and replacement parts.

2. DO NOT use the vacuum on wet surfaces. DO NOT expose to rain or water.

3. DO NOT use or store vacuum in wet or moist conditions.

4. DO NOT try to recover any liquid with this vacuum. This vacuum is for DRY
RECOVERY only.

5. DO NOT USE A DAMAGED VACUUM. If the unit is not working as it should, or if it
has been damaged, left outdoors, or exposed to water, take it to an Authorized
Repair Center for inspection and repair.

6. DO NOT allow the vacuum to be used as a toy. Pay close attention when using the
vacuum near children.

7. DO NOT handle the switch or battery pack with wet hands.

8. DO NOT put any objects into openings. Do not use with any opening blocked, keep
free of dust, lint, hair, and anything that may reduce air flow.

9. Keep hair, loose clothing, fingers, and all parts of body away from openings and
moving parts.

10. Use with extra care when cleaning on stairs.

11. DO NOT vacuum flammable or combustible materials or anything that is burning or
smoking, such as cigarettes, matches, or hot ashes.

12. Sparks inside the motor can ignite flammable vapors, to reduce the risk of fire or
explosion, do not use near combustible liquids, gases, or dusts, such as gasoline or
other fuels, lighter fluid, cleaners, oil-based paints, or natural gas.

13. To reduce the risk of inhaling toxic vapors or dust, DO NOT vacuum or use near
toxic or hazardous materials.

14. DO NOT use without filter in place.

15. Remove battery pack before charging or servicing vacuum.

THIS APPLIANCE IS INTENDED FOR COMMERCIAL USE ONLY.

SERVICING, OTHER THAN NORMAL MAINTENANCE, MUST BE DONE

BY AN AUTHORIZED SERVICE REPRESENTATIVE.

VACO22VDC, PMP22VDC OPERATION INSTRUCTIONS

1. Release the two front fasteners and open the lid.

2. Remove hose and attachment from cover storage area.

3. Remove the orange plug from the filter cartridge and store in unit.

4. Slide one end of the super flex hose into the filter cartridge.

5. Attach appropriate accessories on the hose assembly.

6. Insert Battery into battery receptacle.

7. Close lid and latch securely.

8. Turn on the power switch.

9. These vacuums have a factory installed resettable Thermal Cutout (TCO) for added
operator and motor safety. If the unit gets too hot, the vacuum will shut down.
Please check your hose and utensil for clogs or obstructions. In addition, it may be
time to install a new filter. After checking all the above, please turn vacuum back
on.

FILTER CHANGE-OUT INSTRUCTIONS

Your Omega Cordless includes a full filter indicator light underneath the on/off switch.
This indicator is a guide to provide a visual of when it is time to consider removing the
filter, disposing and inserting a new filter

.

1. Release the two front latches and open the lid.

2. Insert orange plug halfway in contaminated filter cartridge.

3. Lift the filter cartridge out by placing fingertips under lifting tabs located on the
ends of the cartridge and lift up.

4. Push orange plug all the way in.

5. Dispose of the filter cartridge in an appropriate manner compliant with all local,
state, and federal laws.

6. Insert new filter cartridge.

7. Close lid and latch securely.

Your Omega Cordless can be configured to allow its use in and around static sensitive
devices by doing the following:

1. Use *31671STUD hose.

2. Attach *510-001-006 ground cord to hose.

3. Attach other end of ground cord to a known ground or machine ground OR Attach
the banana jack into the *SSISP-101 Statguard and plug into 110V wall outlet.

4. Attach any ESD Safe Utensil to your hose.