Atomic DRZ Instruction And Assembly Manual
Instruction and Assembly Manual
Version 1.1 (2018-June)
Tools Needed (Not Included) :
Equipment required :
Tools Included :
Thank you for purchasing this Atomic product. DRZ is a RWDRear Wheel Drive Dri Chassis in 1:28 scale.
It requires a steering gyro also suitable dri res to work with.
And you need smooth track surface to do dri. It is not recommend to
dri on foam track or high grip carpet. Marble floor, Tile surface, PVC
vinyl floor, Wood desktop, or any kinds of surface that is low tracon is
recommended.
Please read this manual in detail in order to have proper assembly of
this product and wish you have fun with it.
Car Body Radio System Grease
Rim Tire
Battey
Small Screw Driver
1.5mm Allen wrench
1.3mm Allen wrench tool
Hex Nut Driver
4.5mm
Hobby Knife
1
2
Attaching Steering slide
P.1
Linkage Ball
( )2.5mm
use sand paper to
grind the slider
Grease
Lower deck
2x6KM
Slide holder
Suspension mount
!
Caution:
!
Attaching front bulkhead
M1.2x4
Front Bulkhead
0 mm
M1.2 screw for adjust
front arm down stop
Default setup
2x4KM
Adjust the position of Slide Holder
to make sure steering is smooth
and no wobble.
Use sand paper to grind the bottom
of slider to ensure it sliding smooth.
Linkage Ball
( )3.5mm
Adjust the position of Slide Holder
to make sure steering is smooth
and no wobble.
!
3
Front Suspension assembly L/R
4
Attaching Front Suspension
P.2
suspension (L)
suspension (R)
Suspension ball
Linkage Ball end
Linkage Ball end
Suspension ball
1.5x8pin
1.5x8pin
1.5x2.4x0.3
shims (plastic)
2x4KM
Front body mount
suspension
assembly(R)
5
Upper suspension assembly
1.0mm
Camber Adjustable arm
Linkage Ball end
Default setup
!
2.5 degree
7 degree
12.5 degree
Default setup
Attention camber direction
Setup the Shims (plastic) position to setup caster gain
!
Default setup
M1.2x3
L R
1.5x10 pin
Upper Suspension mount
1.5x2.4x0.3
shims (plastic)
2.0mm
Default setup
P.3
Attaching Upper suspension mount
6
M2x6
7
Attaching Steering Assembly
3x6x2
Bearing
3x6x2
Bearing
Steering Block
Front Axles
Linkage Ball
(3.5mm)
Linkage Ball
(4mm)
Linkage Ball
(4mm)
3x6x2
Bearing
3x6x2
Bearing
Front Axles
Steering Block
Linkage Ball
(3.5mm)
Linkage Ball
(4mm)
Linkage Ball
(4mm)
Loading...