Page 1
Hot Water on Demand
Step 4
Connect the Cold water hose to
the inlet on the left side of the unit.
(Don't forget to insert rubbers).
Be sure to use reinforced hose.
Be sure to close it properly.
Step 1
Find the optimal place.
Drill 4 holes and insert Plugs.
Step 2
Open the entrance cable in the
back of the unit.
Be sure to open the side of the
cable
Step 3
Hang the unit on the wall by 4
screws.
Don't forget to inset the electric
cable before.
Step 5
Connect the Hot water hose to the
outlet (Don’t forget the rubbers).
Be sure to use reinforced hose.
Be sure to close it well.
Open the water supply and check for
leakage around the hoses.
If there is no leakage - Go to step 6
If there is leakage, nd the leakage
point and x it.
Check again.
Don’t continue unless you sure
there is no leakage.
Step 6
Connect the electric cable to the
Terminal block.
Step 7
Close the cover by 4 short
screws
After closing the screws
Insert the Gray Bottom cover
NL
OUTLET
INLET
P.N.155197b
Atmor Super 900 - Assembly Steps
Page 2
InLine model Assembly Instructions steps
1
Step 1
Step 2
Open the entrance cable in the
back of the unit.
Be sure to open the side
of the cable
Page 3
InLine model Assembly Instructions steps
2
Step 3
Find the optimal place and stick
the drilling hole template to the
wall.
Drill 4 holes and insert Plugs.
Step 4
Hang the unit on the wall by 4
screws.
Don't forget to inset the electric
cable before.
Page 4
InLine model Assembly Instructions steps
3
Step 5
Connect the Cold water hose
to the inlet on the left side of
the unit. (Don't forget to insert
rubbers).
Be sure to use reinforced hose.
Be sure to close it well.
Step 6
Connect the Hot water hose to the
outlet. (don't forget the rubbers).
Be sure to use reinforced hose.
Be sure to close it well.
Open the water supply and check
for leakage.
If there is no leakage - Go on
If there is leakage, Find the
leakage point and xe it.
Check again
Don't continue anless you sure
there is no leakage.
Page 5
InLine model Assembly Instructions steps
4
Step 8
Put the cover of the unit.
Close the cover by 4 short screws
Step 7
Connect the electric cable to the
Terminal block.
LMN
Page 6
InLine model Assembly Instructions steps
5
Step 09
Insert the Gray Bottom cover
Page 7
InLine model Assembly Instructions steps
6
Step 10
Final view
InLine 3.5kW
InLine 5.0kW
Page 8
InLine model Assembly Instructions steps
7
Step 10
Final view
InLine 7.0kW
Loading...