Atmel REB231ED Quick Start Manual

Atmel AVR2040: REB231ED Evaluation Kit

Quick Start Guide

Features

This application note briefly describes how to set up and run the pre-flashed
performance test application included with the Atmel

The Atmel Controller Base Board (CBB) is intended to serve as the microcontroller
platform for the Atmel Radio Extender Board (REB) family. A REB connected to a
CBB forms a battery powered, fully functional and portable wireless node. The
REB231ED evaluation kit was created for evaluating the Atmel AT86RF231 radio
transceiver.

1 Kit contents

2 x Atmel Controller Base Board (CBB)
2 x REB231ED Radio Extender Board (REB)
2 x RS232 level shifter cable
4 x AAA battery
1 x Quick start guide

®

REB231ED evaluation kit.

8-bit Atmel
Microcontrollers

Application Note

From left to right: 2 x CBB, 2 x REB, 2 x RS232 cable.

2 Board assembling

1. Check/set power switch off on the two CBBs.

2. Insert two batteries in each CBB.

3. Connect each REB to a CCB to create two REB-CBB assemblies.

Expand1
Connector

Rev. 8381B-AVR-09/11