Atlas Metal WSM Parts List

Subsidiary of Mercury Aircraft, Inc.

1135 N.W. 159th DR., MIAMI, FL 33169

PHONE [phone], FAX [phone], E-mail: [e-mail]

PARTS LIST FOR MECHANICAL WATER STATION

WSM

1

3

2

6

7

ITEM NUMBER PART NUMBER DESCRIPTION

1 3020-1 Faucet
2 S81806-0 Splash Guard
3 3018-0 Plastic Drain
4 4710-2 Washer (Not Shown)
5 2050-2 Nut (Not Shown)
6 7002-0+Model # Vinyl Bead Gasket
7 2006-4 1/4 H.P. Compressor
8 1003-0 Power Cord (Not Shown)

9 2028-0 0.044 Cap Tube (Not Shown)
10 2023-0 Drier (Not Shown)
11 2040-0 Thermostat (Not Shown)

MECHANICAL WATER STATION

WSM

-----------------------------------------------------------------------------------------------------------------------------------------------------------------

INSTALLATION

Provide a 16” x 18” cut-out in the counter top and drop the unit in. The vinyl gasket assures complete seating.
A non-toxic silicone seal may be used between the gasket and counter top (not required).
The unit should be level for draining purposes. When installing in a counter, it is recommended that the operator
side be completely open for air circulation. When this is not possible, such as in an island counter, it is
recommended that two grill openings be provided approximately 18” x 18” of free air for intake and exhaust at
opposite ends of the counter.
The unit is supplied with a power cord and a NEMA plug. Refer to the data plate on the compressor housing for
the amperage and voltage information. Use a licensed electrician when installing power source.
After connecting the plumbing the unit is ready to use. It is recommended that the air be purged from the water
system before using.

----------------------------------------------------------------------------------------------------------------------------------------------------------------

OPERATION

The WSM is ready to use approximately 45 minutes after it is plugged in. The unit has been pre-tested and set
for proper operation.

----------------------------------------------------------------------------------------------------------------------------------------------------------------

MAINTENANCE

NEVER CLEAN METAL WITH A CHLORIDE BASED PRODUCT. CHLORIDES OR IMPROPER
CLEANING COULD SCAR, MARK AND/OR CORRODE PANS. DO NOT USE STEEL WOOL OR
ABRASIVE PRODUCTS. TO CLEAN USE SOAPY WARM WATER, RINSE THOROUGHLY TO
REMOVE ALL RESIDUES. CLEAN CONDENSER COIL REGULARLY. FAILURE TO MEET THESE

CONDITIONS WILL VOID WARRANTY.