Atlas Metal WIH-REMOTE Installation Manual

Subsidiary of Mercury Aircraft, Inc.

1135 N.W. 159th DR., MIAMI, FL 33169

PHONE [phone], FAX [phone], E-mail: [e-mail]

WIH-REMOTE INSTALLATION

PANEL WITH CUT-OUT

STUDS

1

3

"

8

GALVANIZED BOX

SCREW

1

1

"

3

"

5

4

DIAL

FRONT FACE

4

"

3

4

4

NUTS

3

1

"

8

INSTALLATION OF THE REMOTE CONTROL HOT UNITS.

--------------------------------------------------------------------------------------------------------------------------------------­Provide the correct Cut-Out opening for the remote control panel (see chart below).
Remove control box from the bottom of the unit.

1) Remove black control dial from front of control panel by loosening screws.

2) Remove 6/32 fiber nuts from the back of the control box.

3) Mount the S/S front plate to the Cut-Out in apron.

4) Attach the galvanized box to the S/S front plate.
The unit is ready to be connected to the electrical receptacle. Refer to the data plate on the control panel for the

amperage and voltage information. Use a licensed electrician when installing power source.

MODEL CUT-OUT SIZE

1 4 1/2 x 6 1/4
2 4 1/2 x 12 1/4
3 4 1/2 x 26
4 4 1/2 x 39 3/4
5 4 1/2 x 53 1/2

CAUTION: HANDLE CONTROL PANEL & CONDUIT CAREFULLY,THERMOSTAT CAPILLARY TUBE IS VERY FRAGILE, IF
BROKEN, HEATING SYSTEM WILL NOT OPERATE.
FAILURE TO MEET THESE CONDITIONS WILL VOID WARRANTY.

6 4 1/2 x 67 1/4