Atlas Metal WCRM Parts List

)

(

Subsidiary of Mercury Aircraft, Inc.

1135 N.W. 159th DR., MIAMI, FL 33169

PHONE [phone], FAX [phone], E-mail: [e-mail]

PARTS LIST FOR CONDIMENT RAIL

WCRM

2

3

4

1

8

5

6

7

9

10

11

ITEM NUMBER PART NUMBER DESCRIPTION

1 S80109-0 1/6 Pan Divider
2 S81453-0 Cover with Handle
3 90-9900 Hinge Bracket
4 86-3202 Perforated Snap-In Drain
5 1003-0 Power Cord
6 2044-0 Thermostat
7 1099-0 Pilot Light
8 2029-0 1/5 H.P. Compressor

9 49-1028 Grommet
10 30-3130 3/4" P.V.C Nipple
11 3016-1 3/ 4" Gat e Val v e
12 2027-0 0.031 Cap Tube (Not Shown
13 2025-0 Drier
16 600008 Thermostat Knob

Not Shown)

REFRIGERATED CONDIMENT RAIL

WCRM

-----------------------------------------------------------------------------------------------------------------------------------------------------------------------

INSTALLATION

Provide a 15" x 62" cut-out in the counter top and drop the unit in.
A non-toxic silicone sealer may be used between the flange and counter top.
The unit should be level for draining purposes. When installing unit in a counter, it is recommended that the
operator side be completely open for air circulation. When this is not possible, such as an island counter, it is
recommended that two grill openings are provided approximately 18” x 18” of free air for intake and exhaust at the
opposite ends of the counter.
The unit is supplied with a power cord and a NEMA plug. Refer to the data plate on the compressor housing for the
amperage and voltage information. Use a licensed electrician when installing power source.

-----------------------------------------------------------------------------------------------------------------------------------------------------------------------

OPERATION

The unit is ready to operate as soon as it is plugged in. The thermostat has an off position and numbers from 1
through 7 (number 7 is the coldest). The unit should be turned off every day after use and turned on one hour before
use.

-----------------------------------------------------------------------------------------------------------------------------------------------------------------------

MAINTENANCE

NEVER CLEAN PANS WITH A CHLORIDE BASED PRODUCT. CHLORIDES OR IMPROPER CLEANING
COULD SCAR, MARK AND/OR CORRODE PANS. DO NOT
PRODUCTS. TO CLEAN USE SOAPY WARM WATER, RINSE THOROUGHLY TO REMOVE ALL
RESIDUES. CLEAN CONDENSER COIL REGULARLY. FAILURE TO MEET THESE CONDITIONS
WILL VOID WARRANTY.

USE STEEL WOOL OR ABRASIVE