Atlas Metal WCMDCL-3 User Manual
Project: ___________
Item No.: ___________
Quantity: ___________
SLIM-LINE DROP-IN SERVING EQUIPMENT
SLIM-LINE
COLD PAN
Refrigerated
Self-Contained
WCMDL-2
SPECIFICATIONS
TOP: Constructed of 18 gauge, type 304 stainless steel, die
stamped with a raised perimeter bead. There shall be a solid
vinyl gasket under the beaded edge to form a seal to the
counter top, thus preventing seepage or marring of the
counter top. Embossed mounting lugs are provided along the
inner surface of the top to hold a full set of removable
separator channels in place.
LINER: The inner liner shall be 18 gauge, type 304 stainless
steel, one piece construction, all welded, ground and polished
to a uniform finish. All corners are coved with a minimum 1/4”
radius. The WCMDL liner has copper tubing firmly soldered to
the exterior BOTTOM ONLY. The WCMDCL liner has copper
tubing firmly soldered to the exterior BOTTOM AND ALL
SIDES. 4” dia. drain with strainer, 4” PVC nipple, and valve is
provided.
INSULATION: The pan is fully insulated with high density
polystyrene, 1" thick on all sides, 1-1/2" thick on the bottom
and enclosed with a 22 gauge galvanized steel outer case.
REFRIGERATION SYSTEM: The compressor housing shall
be fabricated from 14 gauge galvanized angles and bolted to
the base of the unit. A fully self-contained condensing unit is
provided, with a hermetically sealed compressor and a thermostat control. The system is fully charged with CFC free refrigerant and ready to operate.
NOTE: Proper ventilation must be provided in counter
ELECTRICAL: The unit will be wired for 15 amps., 120 volt,
single phase operation, with an on/off thermostat switch and
pilot light. A 6' long, 3-wire cord and plug (NEMA 5-15P) will
be provided.
Specifications subject to change without notice.
9-3/4” Full Depth
WCMDL-2
WCMDL-3
WCMDL-4
WCMDCL-2
WCMDCL-3
WCMDCL-4
STANDARD FEATURES
g
Slim-line configuration - it can install in counters only
16” wide
g
Accommodates your deepest pan or insert - 9-3/4”
deep
g
WCMDCL units have refrigerated copper tubing
around all sides and base - meets your toughest
health department standards
g
Fully insulated for maximum efficiency and energy
savings
g
Factory applied gasket - makes installation a snap and
seals units to the counter top, thus eliminating
seepage
g
Accommodates standard 12” X 20” pans with the use
of separator channel(s), or fractional size pans with
the use of optional adapter bars.
1-Year Parts & Labor Warranty
g
NSF Certified and UL Recognized
g
ACCESSORIES
g
5YW - 5-Year Compressor Warranty
g
WFBL - Stainless steel perforated false bottom
Stainless Steel adapter bars (pg DI-51-52)
g
Stainless Steel adapter plates (pg DI-51-52)
g
g
CPL - Cover Plate with handles, S/S
g
2060-1 - Condensate Evaporator
g
RS - Remote on/off switch for counter mounting
RDVE - Rear Drain Valve Extension
g
* 220 Volt - 50 Cycle Compressor
g
These units have not been performance
tested for use with potentially hazardous foods,
and must be used with ice.
* Units with these accessories are not currently UL listed.
DI-33
16”
A
8”
8”
11-3/4”
13”
MODEL OPEN-
WCMDL-2
WCMDCL-2
WCMDL-3
WCMDCL-3
WCMDL-4
WCMDCL-4
PLAN VIEW
2-3/4”
B
ING
2
3
4
“A” “B” “C” “D” PAN SIZE
46”
(116.8cm)
67-3/4”
(172cm)
89-1/2”
(227.3cm)
C
6-3/8”
(16.1cm)
6-3/8”
(16.1cm)
6-3/4”
(17.1cm)
REMOVABLE SEPARATOR
CHANNELS
ELEVATION
18”
13-3/4”
(45.7cm)
18”
(45.7cm)
21-5/8”
(54.9cm)
(34.9cm)
(34.9cm)
(35.8cm)
11-7/8” X 41-3/4” X 9-3/4”
(30.1 X 106 X 24.7cm)
13-3/4”
11-7/8” X 63-1/2” X 9-3/4”
(30.1 X 161.2 X 24.7cm)
14-1/8”
11-7/8” X 85-1/4” X 9-3/4”
(30.1 X 216.5 X 24.7cm)
11-7/8” ID
ELECTRICAL
CHARACTER-
ISTICS
3.9 amps. -
120V - 1/5HP
3.9 amps. -
120V - 1/5HP
6.8 amps. -
120V - 1/4HP
9-3/4”
D
CUT-OUT
REQUIRED
14-1/4” x 44-1/4”
(36.1 X 112.3cm)
14-1/4” X 66”
(36.1 X 167.6cm)
14-1/4” X 87-3/4”
(36.1 X 222.8cm)
END VIEW
SHIP WT.
(LBS.)
179
(81.1kg)
232
(105.2kg)
278
(126kg)
REMOTE
REFRIGERATION
MODEL
WCMDLX-2
WCMDCLX-2
WCMDLX-3
WCMDCLX-3
WCMDLX-4
WCMDCLX-4
WCMDLX & WCMDCLX - REFRIGERATED COLD PAN
LESS COMP.
SHIP WT.
(LBS.)
138
(62.6kg)
148
(67.1kg)
231
(104.8kg)
COMPRESSORS FOR REMOTE INSTALLATIONS
WITHOUT COMPRESSOR
Units include Refrigerated Cold Pan,
Thermostat, Cap Tube & Drier (for hook up in field
2029 - 1/5 HP for WCMDLX & WCMDCLX -2 & 3
2029-1 - 1/4 HP for WCMDLX & WCMDCLX - 4
by others)
Atlas Metal Industries 1135 NW 159th Dr. Miami, FL 33169 (800) 762-7565 Fax: (305) 623-0475 atlasfoodserv.com
DI-34
05/11-sc
Loading...