ATEN VM7104 Quick Start Manual

VM7104

4-Port VGA Input Board Quick Start Guide

Hardware Review

VM7104 Front View

1. VGA Input Ports

2. Audio Input Ports

3. Status LED

Hardware Setup

VM7104 Board Installation

1. (Optional) Power off the Modular Matrix switch.
Note: The VM1600 I/O boards are hot swappable.

2. On the rear of the VM1600, unscrew the two Phillips head screws and
remove the back panel cover.
Note: The four upper slots are for input boards; the four lower slots

are for output boards.

3. Slide the VM7104 board into the open slot on the VM1600 until it
secures in place.

4. Tighten the two screws on the VM7104 board to fasten it to the
Modular Matrix Switch, until it’s secured to the unit

5. Repeat the steps above if you are installing additional I/O boards.

6. (Optional) Power on the Modular Matrix Switch.

VM7104 Front View

1

2 3

Package Contents

1 VM7104 4-Port VGA Input Board
4 Terminal Block Connectors
1 User Instructions

Important Notice

Considering environmental
protection, ATEN does not
provide a fully printed user
manual for this product. If
the information contained in
the Quick Start Guide is not
enough for you to configure
and operate your product,
please visit our website www.
aten.com, and download the

full user manual.

Online Registration

http://eservice.aten.com

Technical Phone
Support

International:

886-2-86926959

North America:

1-888-999-ATEN
Ext: 4988

United Kingdom:

44-8-4481-58923

© Copyright 2015 ATEN® International Co., Ltd.
ATEN and the ATEN logo are trademarks of ATEN International Co., Ltd. All rights reserved. All other trademarks are the property of
their respective owners.

This product is RoHS compliant.

Installation

1. Using VGA cables connect the video sources to the VGA input ports on the VM7104.

2. Connect the audio source device to the audio input port on the VM7104.

3. (Optional) Power on the Modular Matrix Switch and all devices.

1

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation.

All information, documentation, fi rmware, software utilities, and specifi cations contained in this package are subject to change without
prior notifi cation by the manufacturer. Please visit our website http://www.aten.com/download/?cid=dds for the most up-to-date
versions.

EMC Information

FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
FCC Caution: Any changes or modifi cations not expressly approved by the party responsible for compliance could void the user's authority to operate this
equipment.
CE Warning: This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take
adequate measures.
Suggestion: Shielded twisted pair (STP) cables must be used with the unit to ensure compliance with FCC & CE standards.

The following contains information that relates to China: