ATEN GWLR User Manual

Extender

GWLRHDTX

This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

o

Reorient or relocate the receiving antenna.
o Increase the separation between the equipment and
receiver.
o Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
o Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications to this device not
explicitly approved by manufacturer could void your
authority to operate this equipment.

This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.

To comply with FCC RF exposure compliance requirements,
this grant is applicable to only mobile configurations.
The antennas used for this transmitter must be installed
to provide a separation distance of at least 20 cm from
all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.

IC warning statements:

-English Warning Statement:
"This device complies with Industry Canada licence-exempt RSS
standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference,
including interference that may cause undesired
operation of the device."
This Class B digital apparatus complies with Canadian
ICES-003.

-French Warning Statement:
"Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux
conditions suivantes: (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement."

Cet appareil numérique de la classe B est conforme
à la norme NMB-003 du Canada.
The digital apparatus complies with Canadian
CAN ICES-3 (B)/NMB-3(B).

To comply with ISED RF exposure compliance
requirements, this grant is applicable to only mobile
configurations.
The antennas used for this transmitter must be installed
to provide a separation distance of at least 20 cm from
all persons and must not be co-located or operating in
conjunction with any other antenna or transmitter.

Pour se conformer aux exigences de conformité à l'exposition RF
d'ISED, cette subvention ne s'applique qu'à des configurations
mobiles.
Les antennes utilisées pour cet émetteur doivent être installées
fournir une distance de séparation d'au moins 20 cm de
toutes les personnes et ne doivent pas être localisées ou en
coopération avec une autre antenne ou émetteur.