Atec PA5740 User Manual

PA 574 0

POWER AMPLIFIER/BATTERY SIMULATOR

Battery simulators replace the vehicle battery in the test environment. These sources must fulﬁ ll

various criteria concerning power rating, voltage, slew rate, impedance, etc. depending on the particular

application. Bipolar current sources are speciﬁ ed for in several cases. Pulse 2b, pulse 4, sine wave noise and other complex simulations are realm of the PA 5740. Of course the ampliﬁ er is also perfectly suited for ISO 7637 compliant simulated conducted transient testing. Offering combinations of features that exist in no other battery simulator, the PA 5740 series is the right product at the right price for your EMC

needs.

Capacitive stability mode High bandwidth up to 180 kHz Fast slew rate Ideal for use as synchronized

auxiliary channels required by various EMC standards

Two gain settings for universal

use

Sense lines for cable voltage drop

compensation

Four quadrant operation Banana output connector on both

the front and back of the simulator

Teseq AG

Nordstrasse 11F 45 42 Luter bach Switzerland T + 41 32 681 40 4 0 F + 41 32 681 4 0 48 sales@tese q.com www.teseq.com

Designed speciﬁ cally for automotive EMC testing, Teseq’s 42 V ready ampliﬁ er sets the pace for auto-

motive battery simulation includingfeatures necessary for automotive immunity testing such as sense wires for cable voltage drop compensation and several operating modes for stability with complex automotive loads.

For more details, see the complete catalog “Automotive Electrical Disturbances”.

Specifications subject to change without notice.

Tes eq

is an ISO-registered company. Its products

are designed and manufactured under the strict

quality and environmental requirement s of the ISO

9001. This documen t h as been carefully checked. However, Teseq

errors or inaccuracies.

691-136A February 2011

does not assume any liability for