Atec NC7108 User Manual



NOISE COM, INC.

II.

SPECIFICATIONS

2-1 Frequency Range 100 Hz - 500 MHz

Output Power 10 Mw

Output impedance 50 Ohms.

Input voltage 115 Volts 60Hz (100 & 230V 50Hz Optional).

Noise output is white gaussian noise with a qualified peak

factor.

Control by means of front panel or remotely by means of a controller via IEEE (GPIB), RS-232, RS-422 or RS-423.

INSTRUMENT SPECIFICATIONS



NOISE COM, INC.,

2-2

Non Volatile memory to retain program parameters, GPIB address,

serial baud rate and user programmed control sequences

Baud Rates:

Time Delay:

Programmable Attenuator:

Bandwidth selection:

Standby Position:

Reset:

Second Output:

FUNCTIONAL SPECIFICATIONS

300, 1200 and 9600 to be used with

optional serial interface ports.

1 to 999.9 seconds with .1 second

resolution.

Standard 0-127DB in 1DB steps.

Optional 127.9DB in 0.1DB steps.

Optional band switching filter to

customer specification. Consult

Noise Com.

Power is switched into a dummy load.

A logic reset button is provided.

Optional SPDB Switch to connect either of two outputs.