User Manual
VingCard DLC2
2 66 5013 158-0
FCC (Federal Communications Commission) statements
This device comply with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) The product LCX 7302 may not cause harmful interference, and
2) The product LCX 7302 must accept any interference received, including interference that may cause undesired operation.
Important note: To maintain compliance with FCC´s RF exposure guidelines, this equipment should be installed and operated with minimum distan ce 20 cm between the radiator and
your body. Use only the supplied antenna.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other
antennas or transmitters.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the F CC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio freq uency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
3 66 5013 158-0
Name/Model
Gain
Impedance
F-antenna
-5 dBi
50 ohm
Appellation/Modèle
Gain
Impédance
Antenne
-5 dBi
50 ohm
IC (Industry Canada) statements
This device comply with Industry Canada licence-exempt RSS standard CAN ICES-3 (B)/NMB-3(B) B. Operation is subject to the following two conditions:
1) The product LCX 7302 may not cause interference, and
2) The product LCX 7302 must accept any interference, including interference that may cause undesired operation of the device .
Important note: To comply with Industry Canada RF radiation exposure limits for general population, the antennas used for these transmitters are exempted from Routine Evaluation
Limits – SAR Evaluation in accordance with RSS-102 section 2.5.1.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the tran smitter by Industry Canada.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that
necessary for successful communication.
The product LCX 7302 ‘IC: 9514A-LCX7302C1’ has been approved by Industry Canada to operate with the antenna type listed below with the indicated maximum permissible gain and
required antenna impedance. Antenna types not included in this list, having a gain greater than the maximum gain indicated fo r that type, are strictly prohibited for use with this device.
The term "IC" before the equipment certification number only signifies that the Industry Canada technical specifications were met.
Déclarations d’Industry Canada
Cet équipement est conforme aux normes d’exemption de licence RSS d’Industry Canada CAN ICES-3 (B)/NMB-3(B) B. Son utilisation est soumise aux deux conditions suivantes:
1) Le produit LCX 7302 ne doit pas provoquer d’interférence, et
2) Le produit LCX 7302 doit accepter toute interférence, y compris des interférences susceptibles de provoquer un fonctionnement indésirable de l’équipement.
Remarque importante: Pour respecter les limites d’exposition aux radiofréquences d’Industry Canada pour le grand public, les antennes utilisées pour ces émetteurs-transmetteurs
sont exemptées des limites d’évaluation de routine – évaluation SAR, conformément à la norme RSS-102 section 2.5.1.
Conformément aux réglementations d’Industry Canada, cet émetteur radio peut uniquement fonctionner à l’aide d’une antenne don t le type et le gain maximal (ou minimal) pour ces
émetteurs-transmetteurs sont approuvés par Industry Canada. Pour réduire le risque d'interférence éventuelle pour les autres utilisateu rs, le type et le gain de l'antenne doivent être
choisis de manière à ce que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne soit pas supérieure à la puissance nécessaire à une bonne communication.
Ce produit LCX 7302 ‘IC: 9514A-LCX7302C1’ a été approuvé par Industry Canada pour une utilisation avec les types d’antenne indiqués ci-dessous avec le gain maximum autorisé
indiqué et l’impédance d’antenne requise. Il est strictement interdit d’utiliser avec cet appareil un type d’antenne ne figurant pas dans cette liste ou ayant un gain supérieur au gain
maximum indiqué pour ce type.
Le terme « IC » devant le numéro de certification de l’équipement signifie seulement que les spécifications techniques d’Industry Canada ont été respectées.
4 66 5013 158-0
Successful opening
Find your room. Touch the handle (green light). Enter the room.
Unsuccessful opening
Find your room. Touch the handle (red light). Contact the reception.
5 66 5013 158-0
Loading...