Aspire Spryte User Manual

成品尺寸：34*100MM
料号：2-0025-0927-00

英文

Spryte User Manual

Read this information leaflet
fully before you start using
this product as it contains
important information. The
notes below relate to when
the device is filled with e-liquid
that contains nicotine.

This product is intended for adult
smokers. This product is not
recommended for non-smokers,
young people under the age of
18 years, pregnant or breast
feeding women and those
experiencing general ill health.

Drip Tip

Protective Cap

Drip Tip

Spryte Pod

Airflow vent

Fire Button

Micro USB Charging Port

Keep out of reach of children and minors！

This product contains nicotine which is

a highly addictive substance.

The above warning only applies when this device has

been filled with nicotine containing e-liquid

Contents:

1* Spryte device
2* Extra O rings

2* Coils (1*1.8Ω & 1*1.2Ω for

Nic Salt)
1* Micro USB Cable
1* Warranty Card
1* User Manual

Regular
BVC coil

Specifications

• Spryte Pod capacity: 2ml

• Spryte coil is

interchangeable with

original CE5 BVC coils

• Built-in Battery Capacity:
650mAh

• Dimensions: 108*26*26mm

• Adjustable airflow

• Coil resistance:1.8ohm

• Coil type: Nichrome

• Easy bottom fill

• Output wattage:12W

• When using a new coil, let

the pod stand for 5
minutes after filling so the

cotton can be saturated with e-liquid
before use.

• Do not let the pod become

completely empty. Refill the pod to
avoid dry burning or damage to the
coil.

Spryte Filling

1 .Pull and remove the pod
from the main body of the
Spryte.

2. Invert the pod and place
the filling bottle/dropper

1.2Ω for

Nic Salt

1 2

into the pod filling hole

3. Push down and squeeze
the filling bottle/dropper
bulb to add your preferred
e-liquid into the pod
system.

4. Re-insert the pod into the
ower unit, and push down
firmly until it 'clicks' into
place.

Spryte Coil Installation

1. Pull and remove the pod
from the main body of the
Spryte.

2. Invert the pod, push down
and unscrew to disengage
the chimney unit, then
remove.

3. Detach the atomizer from
the airflow control ring and
replace it with a new one.

4. Push down and screw in to
relocate the chimney unit
back to the pod system.

5. Re-inset the pod into the

power unit, and push down

firmly until it 'clicks' into
place.

Note: 1. To adjust the airflow

of the Spryte, please
remove the pod and rotate
the airflow control ring on
bottom of the Spryte pod;

2. When relocating the
chimney unit, please screw
and push down at the same
time.

Instructions

• Pressing the fire button five

times within two seconds

3 4 5 6 7

will turn the device on or

off. The indicator lights will
flash blue and red three
times to indicate off or on.

• When the Spryte is on,

press the fire button the
lights will indicate your
Spryte current charge.
When its current charge
capacity is above 3.8 volts
the indicator lights will be
blue and red. When the
charge is between 3.8 and

3.5 volts the lights will be
blue only. When the charge
drops below 3.5 volts the
lights will then become red
to remind you that it is time
to charge your Spryte.

Protective Features

• Automatic Cutoff: The

preset continuous fire time
is 15 seconds, after 15
seconds of continuous
firing, the LED lights will
flash blue and red 10 times
and the Spryte will stop
firing, it will fire again when
the button is pressed.

• Short Circuit Protection:

When the Spryte detects a
short, it will stop firing, and
the LED lights will flash
blue and red 3 times .

• Low Voltage Protection:

When the battery level
drops below 3.2V, the
Spryte will not function and
the LED lights will flash red
15 times.

• Overcharge Protection:

When the Spryte is fully
charged, it will stop
charging to prevent
overcharging of your
battery.

• Over heat protection: When

the temperature of the
control board is above 75

O

C/167 OF, will on blue and
red for 3 seconds to remind
overheat and the Spryte will
cut off.

Charging Instructions

• Charge via the Micro USB

port. Maximum charge
current can reach up to
1000mA.

• When the USB cable is

attached the Spryte
indicator lights will flash
blue and red three times.
While charging the LED will
indicate the Spryte’s current
charge status: 3.5 volts or
less= red light; 3.5 to 3.8
volts= blue light; 3.8 volts
and above =both blue and
red lights. When the Spryte
is fully charged the LED will
flash blue and red 20 times
then remain off.

IMPORTANT INFORMATION
ABOUT USING NICOTINE
CONTAINING E-LIQUIDS

Before using nicotine
containing e-liquids the user
should read the following
information carefully.

NICOTINE CONTAINING
E-LIQUIDS:

Do not use if you are allergic
to nicotine or any of the other
ingredients contained within
the e-liquid (see
manufacturer’s abel for full
details).

WARNINGS AND
PRECAUTIONS

Nicotine containing e-liquids
are not recommended for:

• Non-smokers

• Young people under the age

of 18 years;

• Pregnant or breast feeding
women; as nicotine is
known to cross the placenta
known to cross the placenta
and to be excreted in breast
milk;

• Those experiencing general
ill health; such as heart
disease, stomach and
duodenal ulcers, liver or
kidney problems, long term
throat disease or difficulty
breathing due to bronchitis,
emphysema or asthma;

• Those who have an
overactive thyroid gland or
have a
phaeochromocytoma(a
tumour of the adrenal gland
that can affect high blood
pressure);

• Those who have diabetes,
as nicotine may affect your
blood sugar levels.

• Those taking the following
medication;

• Theophylline (to treat
breathing problems)

• Ropinirole (to treat restless
leg syndrome)

• Clozapine (to treat
schizophrenia)

POSSIBLE SIDE EFFECTS

If you inhale too much
nicotine or use the product
too much you may
experience one or more of
the following effects:

• Feeling faint;

• Nausea (feeling sick)

• Headache

• Coughing

• Irritation of the mouth or

throat

• Dizziness

• Stomach discomfort

• Hiccups

• Nasal congestion

• Vomiting (being sick)

• Heart palpitations

• Abnormal heart rate

If you experience any of
these side effects; including
any possible side effects not
listed in this leaflet,
discontinue using the
product, if the effect(s)
continue after you stop use,
consult your doctor or
healthcare professional and
bring this leaflet to their
attention.

2.8

mm

*Diameter of the pod refill hole.

To learn more about your products
and how to use, please visit:

www.aspirecig.com

Shenzhen Eigate Technology
Co., Ltd.

Building 3, Xinhongtai Industrial Park,
14 Jian'an Rd, Tangwei, Fuyong
Town, Bao'an District, Shenzhen,
China
Tel: [phone]
Email: [e-mail]

Manufactured By Eigate MADE IN CHINA