Aspire Slym User Manual

Slym User Manual
Read this information leaflet fully before you start using this product as it contains important information. The notes below relate to when the device is filled with e-liquid that contains nicotine.
This product is intended for adult smokers. This product is not recommended for non-smokers, young people under the age of 18 years, pregnant or breast feeding women and those experiencing general ill health.
Drip Tip
E-liquid Window
Micro USB
Charging Port
Indicator
Light
Fire Button
Contents:
1* Slym mod 1* Micro USB cable 1* User manual 1* Warranty card
Specifications
Coil resistance: 1.2Ω
Coil material: Nichrome Non-adjustable airflow Continuous firing time: 10 seconds Output wattage: Bypass Output voltage: 3.0-4.2V Built-in battery capacity: 1000mAh Diameter: 20mm Length (including drip tip): 108mm
Pod Activation
1. Push the coil into the body of the disposable pod;
2. Allow the pod complete with coil to stand for 5 minutes, so that the cotton can become fully saturated with e-liquid before use.
Pod Installation
1. Unscrew the top cap and remove it from the device;
2. Attach the activated pod, complete with the fully saturated coil to the top cap and screw the whole unit back into the metal sleeve of the device.
Note: No pods are included in this package. Pods are
sold separately.
Instructions
Press the fire button 5 times within 2 seconds to either lock or unlock the device, and the LED light will flash white 3 times at the same time.
When the device is on, press the fire button, the LED light will indicate your device's current charge. When its current charge capacity is above 3.8 volts, the light will be green. When the charge is between
3.8 and 3.5 volts, the light will be blue. When the charge drops below 3.5 volts, the light will then become red to remind you that it is time to charge your device.
Protection Features
Automatic Cutoff: The preset continuous fire time is 10 seconds, after 10 seconds of continuous firing, the device will stop firing and the LED light will flash purple 10 times, it will fire again when the button is pressed.
Short Circuit Protection: When the device detects a short, it will stop firing, and the LED light will flash purple 3 times.
Low Voltage Protection: When the battery level drops below 3.2V, the device will not function and the LED light will flash red 15 times.
Overcharge Protection: When the device is fully charged, it will stop charging to prevent overcharging of your battery.
Over Heat Protection: When the temperature of the control board is above 75/167, the LED light will remain on yellow for 3 seconds to indicate overheat and the device will cut off.
Charging Instructions
Charge via the Micro USB port. Maximum charge current can reach up to 1A.
When the USB cable is attached the device indicator light will flash red 3 times. While charging the LED will indicate the device’s current charge status: 3.5 volts or less= red light; 3.5 to 3.8 volts= blue light; 3.8 volts and above =green light. When the device is fully charged the LED will flash green 20
times then remain off. When the USB cable
is detached the indicator light will flash green 3 times.
MPORTANT INFORMATION ABOUT USING NICOTINE CONTAINING E-LIQUIDS
Before using nicotine containing e-liquids the user should read the following information carefully.
NICOTINE CONTAINING E-LIQUIDS:
Do not use if you are allergic to nicotine or any of the other ingredients contained within the e-liquid (see manufacturer’s label for full details).
WARNINGS AND PRECAUTIONS
Nicotine containing e-liquids are not recommended for:
Non-smokers
Young people under the age of 18 years;
Pregnant or breast feeding women; as
nicotine is known to cross the placenta and to be excreted in breast milk;
Those experiencing general ill health; such as heart disease, stomach and duodenal ulcers, liver or kidney problems, long ter throat disease or difficulty breathing due to bronchitis, emphysema or asthma;
Those who have an overactive thyroid gland or have a phaeochromocytoma (a tumour of the adrenal gland that can affect high blood pressure);
Those who have diabetes, as nicotine may affect your blood sugar levels.
Those taking the following medication;
Theophylline (to treat breathing problems)
Ropinirole (to treat restless leg syndrome)
Clozapine (to treat schizophrenia)
POSSIBLE SIDE EFFECTS
If you inhale too much nicotine or use the product too much you may experience one or more of the following effects:
Feeling faint;
Nausea (feeling sick)
Headache
Coughing
Irritation of the mouth or throat
Dizziness
Stomach discomfort
Hiccups
Nasal congestion
Vomiting (being sick)
Heart palpitations
Abnormal heart rate
If you experience any of these side effects; including any possible side effects not listed in this leaflet, discontinue using the product, if the effect(s) continue after you stop use, consult your doctor or healthcare professional and bring this leaflet to their attention.
Safety note:
To avoid misfiring always ensure you either
lock or switch off your device when it is not in use. Especially when carrying your device in your pocket, bag or purse.
To learn more about your products and how to use, please visit:
www.aspirecig.com
Shenzhen Eigate Technology Co., Ltd.
Building 3, Xinhongtai Industrial Park, 14 Jian'an Rd, Tangwei, Fuyong Town, Bao'an District, Shenzhen, China Tel: +86-755-81499783 Email: service@aspirecig.com
Manufactured By Eigate MADE IN CHINA
1 2 3 4 5
Loading...