Aspire K2 User Manual

Protective Features

1. Automatic cutoff: After 15 seconds of use the device will cease
firing and the LED light will flash both blue and orange ten
times.

2. Short circuit protection: If the K2 detects a short circuit the
device will immediately cease firing and the light will flash both
blue and orange three times.

3. Low voltage protection: When the K2’s charge drops to 3.2
volts the LED will flash orange fifteen times and the device will
stop functioning.

4. Overcharge protection: When the battery has fully charged to

4.2 volts the K2 will automatically stop charging.

5. High temperature protection : If the control board detects its
temperature over 167 degrees Farhenheit/75 degrees Celsius
the device will cease functioning, the LED light will turn both
orange and blue for 3 seconds.

Specifications

1. K2 tank capacity: 1.8ml

2. K2 atomizer: Kanthal 1.60 ohm

3. K2 battery capacity: 800 mah

4. K2 battery output voltage: 5.5V (without atomizer)

Charging Instructions

When the usb cable is attached and the K2 begins charging

the button will flash blue and orange three times. While
charging the LED will indicate the K2’s current charge status,

3.5 volts or less will be indicated by an orange light, 3.5 to

3.8 volts is indicated by a blue light, charge above 3.8 volts

is indicated by both blue and orange lights. when the K2 fully
charges the LED will flash blue and orange 20 times. When
you unplug your K2 the button will flash blue and orange
three times.

User manual for

K2 Quick Start kit

Thank you for choosing the Aspire K2

Quick Start kit. This simple and
convenient kit just needs ejuice and
you’re ready to go. The K2 kit features
usb charging and a refillable tank.
Using Aspire’s Bottom Vertical Coil
technology the K2 will give you an
amazing mouth to lung experience
with flavor that no cigarette can
match.

Instructions

1. Pressing the fire button five times within
two seconds will turn on and off the K2
battery. The fire button will flash blue and
orange three times to indicate off or on.

2. When the K2 is in use the light on the
button will indicate your K2’s current
charge. When the K2’s current charge
capacity is above 3.8 volts the fire button
will be blue and orange. When the charge
is between 3.8 and 3.5 volts the button
will be blue only. When the charge drops
below 3.5 volts the light will then become
orange to remind you that it is time to
charge your K2.