Aspire K1 User Manual

K1 Stealth kit

User Manual

Read this information leaflet fully before you start using this product as
it contains important information. The notes below relate to when the
device is filled with e-liquid that contains nicotine.

This product is intended for adult smokers. This product is not recommended
for non-smokers, young people under the age of 18 years, pregnant or breast
feeding women and those experiencing general ill health.

Drip tip

Fire button

Glass tube

Airflow

control ring

Mode button

Coil

Indicator light

Micro USB

Charging Port

Wattage lights

Contents:

1* K1 Stealth mod
1* K1 Plus tank

2* Nichrome coils (1*1.6Ω & 1*1.8Ω preinstalled)

1* Metal connecting ring
1* USB cable
1* User manual
1* Warranty card

Tank Features

Easy Top fill
Top and bottom child lock mechanism

1.9ml capacity
Airflow adjustable
Leak free refill system
Coil resistance: 1.8Ω (9-13W), 1.6Ω (6-11W)

Coil material: Nichrome

Tank is compatible with aspire original BVC coils and Spryte coils

Diameter: 16mm

Length (including drip tip): 57mm

Tank Filling

1. Push down the drip tip and unscrew to remove it from the tank;

2. Add your preferred e-liquid by pushing the tip of your filling
bottle through the filling hole;

3. Put the drip tip back on top of the tank then push down and
screw at the same time to secure it.

• When using a new coil, let the tank stand for 5 minutes after
filling so the cotton can be saturated with e-liquid before use.

• Do not let the tank become completely empty. Refill the tank to
avoid dry burning or damage to the coil.

1 43 5 6 72

Coil Installation

1. Invert the tank, push down the base hardware and unscrew to
disengage it;

2. Push and unscrew to remove the used coil and also push and
screw to install a new one;

3. Push down and screw in to relocate the base hardware.

Note: The pressing and twisting operations in each step are

performed simultaneously.

Mod Specifications

Optional output wattage: 8W, 10W, 12W
Supported resistance range: 1.0-2.0Ω
Continuous firing time: 10 seconds
Firmware update: N/A
Bottom wattage lights
Dimensions: 39*68*21mm
Battery type: Built-in LiPo
Battery capacity: 1000mah

Instructions

• Tank installation

1. Screw the metal connecting ring to the bottom of the K1 Plus
tank;

2. Insert the tank into the mod, the tank will be magnetically drawn
into the mod and be held in place.

Note: In order to avoid dry burning and damage to the coil,

please fill the tank before installation.

• Power on/off

Pressing the fire button 5 times within 2 seconds will turn the

device on or off. The indicator light will flash white 3 times to
indicate off or on.

• Vaping

When the device is on, press the fire button, the indicator light

will indicate your device's current charge. When its current
charge capacity is above 3.8 volts, the indicator light will be
green. When the charge is between 3.5 and 3.8 volts, the light
will be blue. When the charge drops below 3.5 volts, the light will

then turn red to remind you that it is time to charge.

• Set the output wattage

Press the bottom mode button twice in rapid succession to

adjust the output wattage. The bottom wattage lights will turn on
to indicate the level of the output wattage: one light illuminated is
8W, two lights illuminated is 10W, three lights illuminated is 12W.

Protection Features

• Automatic cutoff: The preset continuous fire time is 10 seconds,

after 10 seconds of continuous firing, the indicator light will flash
pink 10 times and the device will stop firing.

• Short circuit protection: When the device detects a short, it will

stop firing, and the indicator light will flash pink 3 times.

• Low voltage protection: When the battery level drops below 3.2V,

the device will not function and the indicator light will flash red 15
times to remind you to charge the device.

• Overcharge protection: When the device is fully charged, it will

stop charging to prevent overcharging of your battery.

• Over heat protection: When the temperature of the chip is above

75℃/167℉, the indicator light will be yellow for 3 seconds and
the device will cut off.

Charging Instructions

• Charging the K1 Stealth via Micro-USB charging port, the
maximum current can reach up to 2A.

• When the USB cable is attached, the indicator light will flash red
3 times. While charging the indicator light will indicate the
device’s current charge status: 3.5 volts or less= red light; 3.5 to

3.8 volts= blue light; 3.8 volts and above =green light. When the
device is fully charged, the indicator light will flash green 20
times then remain off. When unplug the USB cable, the indicator
light will flash green 3 times.

IMPORTANT INFORMATION ABOUT USING NICOTINE
CONTAINING E-LIQUIDS

Before using nicotine containing e-liquids the user should read the
following information carefully.

NICOTINE CONTAINING E-LIQUIDS:

Do not use if you are allergic to nicotine or any of the other
ingredients contained within the e-liquid (see manufacturer’s label
for full details).

WARNINGS AND PRECAUTIONS

Nicotine containing e-liquids are not recommended for:

• Non-smokers

• Young people under the age of 18 years;

• Pregnant or breast feeding women; as nicotine is known to cross
the placenta and to be excreted in breast milk;

• Those experiencing general ill health; such as heart disease,

stomach and duodenal ulcers, liver or kidney problems, long

term throat disease or difficulty breathing due to bronchitis,
emphysema or asthma;

• Those who have an overactive thyroid gland or have a
phaeochromocytoma (a tumour of the adrenal gland that can
affect high blood pressure);

• Those who have diabetes, as nicotine may affect your blood
sugar levels.

• Those taking the following medication;

• Theophylline (to treat breathing problems)

• Ropinirole (to treat restless leg syndrome)

• Clozapine (to treat schizophrenia)

POSSIBLE SIDE EFFECTS

If you inhale too much nicotine or use the product too much you
may experience one or more of the following effects:

• Feeling faint;

• Nausea (feeling sick)

• Headache

• Coughing

• Irritation of the mouth or throat

• Dizziness

• Stomach discomfort

• Hiccups

• Nasal congestion

• Vomiting (being sick)

• Heart palpitations

• Abnormal heart rate
If you experience any of these side effects; including any possible
side effects not listed in this leaflet, discontinue using the product,
if the effect(s) continue after you stop use, consult your doctor or
healthcare professional and bring this leaflet to their attention.

Safety note:

To avoid misfiring always ensure you either lock or switch off
your device when it is not in use. Especially when carrying
your device in your pocket, bag or purse.

3

mm

*Diameter of the pod refill hole.

To learn more about your products and how to use,
please visit:

www.aspirecig.com

Shenzhen Eigate Technology Co., Ltd.

Building 3, Xinhongtai Industrial Park, 14 Jian'an Rd,
Tangwei, Fuyong Town, Bao'an District, Shenzhen, China
Tel: [phone] Email: [e-mail]

Manufactured By Eigate MADE IN CHINA