Asko W660 Installation Instruction

Laundry
Washers
Dryers
Under Counter Installations
These units can be installed in free-standing installa­tions. This shows the traditional built-in layout: dryer on left and washer on right. To reverse this, simply reverse the installation specs. These units can also be built in under a 34" to 35" high counter. The minimum counter width is 49" for a pair. This 49" width allows 1/2" of space on the outside edges and between the units, otherwise units may bump wall/cabinet or each other during spin cycles. This also allows for sufficient air circulation for dryer.
Electrical, Water And Code Requirements
The washers have a 220 V line that plugs into an ASKO dryer or a standard 220 V, 20 amp single phase outlet. ASKO dryers plug into standard 220V, 30 amp circuit. The washers connect to the cold-water outlet. The water pressure must be between 15 – 146 PSI. Second floor (above grade) installations must meet all local building codes.
See Use & Care Guide for detailed installation instructions.
23-7/16"
33-1/2"
to 34-1/2"
23-7/16" or 24-7/16"
23-7/16"
33-1/2"
to 34-1/2"
23-7/16" or 24-7/16"
23-7/16" or 24-7/16"
67" to 69"
23-7/16"
Depth with Door Open
W600 & W640 — 36-3/8" W620 & W660 — 42-3/8"
Depth with Door Closed
W600 & W620 — 24-7/16" W640 & W660 — 23-7/16"
Depth with Door Open
46-1/16"
Depth with Door Closed
T700 & T720 — 24-7/16" T760 & T780 — 23-7/16"
5-1/2"
23-3/4" or 24-3/4"
49" Minimum
34"
to 35"
15-3/4" Minimum
Hot & Cold Water
4-23/32"
4-1/8"
Drain
Hole Diameter 5-1/2"
5-1/2"
220V, 30 Amp Outlet
18
I
NSTALLATION
Loading...