Asko W620 Quick Start Guide

Washer Quick Start Guide

W620

We know you’re excited about owning an ASKO washing machine and you’re anxious to get started, so here is a brief summary of the operating procedures. To get the most of the features of your machine, we recommend that you read your Use and Care Guide.

THE CONTROL PANELTHE CONTROL PANEL

Door Open Button

Press to open the glass door. Please note that the Program Control knob must be at the end of a program (at a red mark) to open the glass door.

Power Indicator Light

Glows when the power is turned on.

Power Button

Press to turn on power to the machine.

2 5h

Economy Button

Press to extend the wash time by 22 minutes. (Suggested for use only with the low wash temperatures.)

1100

1000

1200

700

800

900

205

600

170

160

Temperature Control

Turn clockwise to set the wash temperature.

105

120

140

Super Rinse Button

Press to program two additional rinses.

Delay Start Button

Press to delay starting the program for five hours.

Spin Speed Control

Turn clockwise to select the spin speed for the final spin.

Program Control

Turn clockwise to select a program.

Power ButtonPower Button

The Power button turns the power to the machine on and off. When the power is on, the power indicator light glows red. The power must be on before you can open the glass door, set the programs or start the machine.

Door Open ButtonDoor Open Button

The power must be on and you must press this button to open the glass door. There will be a few seconds delay before the door opens. Please note that the Program Control knob must be at the end of a program (at a red mark) to open the glass door. See also, “Interrupting or Changing a Program” on the next page.)

For instructions on how to open the door manually in case of power failure, refer to your Use and Care Guide.

PROGRAMS AND OPTIONSPROGRAMS AND OPTIONS

Your ASKO washer has several programs and options specifically designed to give you the cleanest laundry possible. The tables below define each program and option. The C and S on the Program Control are fault codes, which are explained on the next page.

Program Recommended Number Program Types of Laundry Temp. Range (° F)

1 White cotton w/prewash For heavily soiled cotton 140–205 2 White cotton w/short prewash For normally soiled cotton 140–205 3 Normal For lightly soiled cottons and colorfast fabrics 105–140 4 Rinse 5 Long spin 6 Permanent Press/Synthetics For acrylic, polyester 105–140 7 Super quick wash For lightly soiled fabrics 85–105 8 Short spin 9 Wool/Hand wash For silk, nylon, washable wool 85–105

10 Drain

CAUTION!

DefinitionOption

Super Rinse – Provides two additional rinses. Recommended for persons with sensitive skin or allergies.

Economy – Extends the main wash time by 22 minutes. When used with low wash temperatures (85°–100° F), this program

conserves energy but gives the same high level of cleaning. Note: You can only use this option with programs 1, 2 and 3.

Delay Start – Automatically delays starting the program for five hours.

Spin Speed Control

In addition to the 600 rpm to 1200 rpm spin speed options, the Spin Speed Control has a No Spin/No Drain option ( ) and a No Spin ( ) option. These are for delicate fabrics that should not be spun dry.

Some fabrics may not be able to withstand extremely hot temperatures. Refer to the Recommended Wash Temperatures chart in the Use and Care Guide.

QUICK START PROCEDURESQUICK START PROCEDURES

Press the Power button ( ) to turn on the machine.

Press the Door Open button ( ) to open the door and load the wash. (The door will open in a few seconds.)

Check that the door is clear of laundry then close it firmly. (It won’t shut if it’s slammed.)

Pour the detergent and fabric softener into the proper compartments in the detergent drawer, as illustrated below. (Don’t put detergent in the prewash compartment unless you plan to prewash.)

Close the drawer securely. (Do not slam it closed.)

Turn the Temperature Control knob to the desired wash temperature.

Set the Spin Speed Control knob to the desired rpm (optional).

Select program options, such as No Spin or Super rinse.

Turn the Program Control knob to the desired wash program. The machine will start.

THE DETERGENT DRAWERTHE DETERGENT DRAWER

W620

The detergent drawer on ASKO washers automatically dispenses the detergent and fabric softener at the appropriate times. The drawer is located to the left of the control panel. Simply pull the drawer out and pour the measured amounts of detergent and softener into the proper compartments (as illustrated) and close the drawer.

NOTE:

We recommend that you don’t use bleach in your ASKO washer.

The tumbling wash action, temperature control options and extended wash times are sufficient to remove most stains.

Main wash detergent

The detergent drawer is equipped with an optional child safety catch. (See your Use and Care Guide.)

Prewash detergent

Fabric softener

DETERGENT AND FABRIC SOFTENER AMOUNTSDETERGENT AND FABRIC SOFTENER AMOUNTS

Because ASKO washers use less water than conventional top-loading washers, you need less detergent and fabric softener. We recommend that you use a low-sudsing powder detergent only, preferably a high-efficiency (HE) detergent designed specifically for front-loading washers. (Liquid detergents tend to suds more, which make them more difficult to rinse out.)

Detergent – The amount of detergent needed varies, depending on the detergent you use. For high-efficiency detergent specifically for

front-loading washers, you should use the amounts recommended by the manufacturer. For regular laundry detergent, 1 to 3 tablespoons of detergent is all you need for a normal wash load. More heavily soiled items, however, may need slightly more detergent. Also, the amount

of detergent needed can vary due to differences in water hardness. (Refer to the Use and Care Guide for more details.) If you choose to use a liquid detergent, start out with a very small amount, such as one or two tablespoons.

Fabric Softener – We recommend that you use only 2 tablespoons of fabric softener. If more softening is desired, try using slightly more

with the next load.

INTERRUPTING OR CHANGING A PROGRAMINTERRUPTING OR CHANGING A PROGRAM

If you need to stop or interrupt a program after you start the machine, turn the Program Control knob to 10 (Drain). Any water in the machine will be pumped out. Press the Door Open button to open the door. (It won’t open until the water is out.) To restart the washer, close the door, add detergent (if needed), and turn the controls to the desired settings.

FAULT CODESFAULT CODES

The Program Control knob has two fault codes: C and S. If the knob stops on one of these, the machine detected a problem.

C – This indicates a problem that can probably be taken care of without calling a service technician. S – This usually indicates a mechanical problem and a service call will be required.

Refer to the “Troubleshooting” section in your Use and Care Guide for more detailed information.

COMMONLY ASKED QUESTIONSCOMMONLY ASKED QUESTIONS

1) Where do I put the fabric softener?

2) Why does the machine run longer than my old top-loader?

3) The machine won’t start.

4) The machine won’t spin.

5) The door won’t open.

(For more troubleshooting issues, refer to the “Troubleshooting” section in your Use and Care Guide.)

ANSWERSANSWERS

1) See illustration above.

2) One reason ASKO washers clean better than others is because they have longer wash cycles and extra rinses. Also, if the water entering the machine is exceptionally cold, it will take longer to heat, therefore increasing the cycle time.

3) a) Make sure the unit is securely plugged into the wall outlet. b) Be sure the Power button is pushed in and the indicator light is red. c) The door must be closed securely (but don’t slam it). d) The Program Control knob may not be in the proper

position for the beginning of a program.

e) Check the house breaker and fuses.

4) Check the pin trap for an obstruction blocking the pump or outlet hose.

5) See “Door Open” on the previous page and Answer 3 above.