ASKO HG1885SD User Manual
OPERATION
Description
6
4
5
7
Ignition and adjustment
2
3
4
1
2
3
5
6
1
1. zone indication
2. 0 position
3. High setting
4. Low setting
5. Wok setting (wok burner)
6. Roasting setting (wok burner)
Each burner is fully adjustable between high and low settings.
• Press the control knob and turn it anticlockwise. The burner will ignite.
• Keep the control knob fully depressed for at least 3 seconds
• If desired, turn the wok selector ring to the roasting setting (6).
4
• The wok burner will switch automatically to the wok setting if the
It is possible to switch between wok setting and roasting setting and
back during cooking.
1 3
8
between high and low settings. The thermocouple safety pilot has
been activated.
The inner ring (wok setting) will switch off and the outer ring
(roasting setting) will switch on.
control knob of the wok burner is set to 0.
2
1. standard burner
2. rapid burner
3. simmer burner
4. wok burner
5. pan support
6. glass top or stainless steel
drip tray
7. wok selector ring
8. control knob
Please note! If the control knob is in the off setting (0-setting) the
selector ring cannot be changed to the roasting setting. Always turn this
knob back completely to 0!
EN 3
OPERATION
Use
error
good
wok ring
Pans
• Always ensure than the flames stay under the pan. A lot of energy
is lost if flames burn around the pan. The handles may also become
too hot.
• Do not use pans with a base diameter smaller than 12 cm. Smaller
pans are not as stable.
Wok ring and small pan grid
The wok ring for use with the wok burner supplied or obtainable as an
accessory provides extra stability for woks with a round base. The small
pan grid supplied or obtainable as an accessory makes it possible to
use very small pans.
Do not use the small pan grid on the wok burner. Do not use the wok
ring on the wok roasting setting. This can result in discolouring.
EN 4
Pan support
Place the pan supports vertically, without sliding over the drip tray. Use
the leads to position the pan supports on the drip tray.
small pan grid
MAINTENANCE
1
1
Burner
Use the leads (1) to put together the burner parts.
Wok burner
Place the wok burner correctly. Placing the wok burner parts incorrectly
can result in a poorly functioning burner.
1. Place the burner distributor (2) in the burner housing (1).
2. Use the leads to place the inner ring (3) on the burner distributor (2).
3. Use the leads to place the outer ring (4) on the burner distributor (2).
4
2
3
1
position distributor
4
3
2
1
2
position rings
side view
EN 5
Loading...