READ ALL OF THESE INSTRUCTIONS BEFORE INSTALLING THE DISHWASHER.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
492183_492185 Install DW Outdoor USA EN Rev 01.indd 12015-01-13 11:14:22
INTRODUCTION
Read these instructions carefully and completely before
you install the machine. The installation should be
carried out by a qualified person who is familiar with all
local codes and ordinances for electrical and plumbing
connections.
WHAT YOU NEED
TOOLS
1) Phillips No. 2 screwdriver
2) Flat blade screwdriver
3) Torx screwdriver size T 20
4) Adjustable wrenches (if you use copper fittings)
5) Open-ended wrench (1/2˝ [12 mm] or 5/8˝ [16
mm])
6) Tape measure
7) Spirit level
8) Electric drill with 1-1/2˝ drill bit
9) Keyhole saw
MATERIALS
• Minimum 3/8" OD copper tubing of sufficient length for
your installation.
• Shut-off valve and fittings for water supply line.
NOTE:
Cosmetic damage must be reported to the ASKO dealer
within five days from the date of purchase. As soon as
you unpack the dishwasher, thoroughly check it for
cosmetic damage.
AUTOMATIC HIGH LOOP
The drain hose is fastened to the back of the machine at the best height. To eliminate potential drain problems,
leave this hose in place.
23
492183_492185 Install DW Outdoor USA EN Rev 01.indd 22015-01-13 11:14:22
CUSTOMER CARE CENTER 1-800-898-1879 • WWW.ASKONA.COMCUSTOMER CARE CENTER 1-800-898-1879 • WWW.ASKONA.COM
SAFETY INSTRUCTIONS
• It is important that you closely follow the instructions
provided here.
• An incorrect or defective installation can lead to
higher consumption of energy, water and dishwashing
detergent, which can lead to higher costs and poor
cleaning results.
• Plumbing and electrical installations must be carried
out by qualified professionals.
• Exercise caution during the installation! Wear
protective gloves! Always work in pairs!
BEFORE STARTING THE INSTALLATION
Connection to water supply:
• There must be a shut off valve on the water supply
pipe. The shut off valve should be installed in a
location that is easily accessible so that the water may
be shut off in the event that the dishwasher needs to
be moved.
Installation advice:
• Cable holes for wires/cables need not be larger than
1-1/2˝ (38 mm).
• The power outlet for the dishwasher should be
installed in a location that is easily accessible once
the dishwasher is installed.
• Always follow the applicable regulations for water,
drain and electrical connection.
• If a dishwasher must be hard wired, it must be
connected to a grounded circuit.
WARNING!
Turn off the water supply when installing the
dishwasher!
NOTE:
Check that the fitting and connection measurements
are correct. See UNIT DIMENSIONS and PREPARING
THE LOCATION.
492183_492185 Install DW Outdoor USA EN Rev 01.indd 32015-01-13 11:14:22
UNIT DIMENSIONS
98 mm
124 mm
241 mm
U.S.Metric
Height (Adjustable) 35˝ to 35-3/4˝889 to 908mm
Width 24-5/8˝ 625 mm
Depth (Includes high loop) 25˝ 635 mm
DepthW/handle27˝686 mm
Depth W/Door Open51-5/8˝1311 mm
Weight163 Ib74 kg
27"
24-5/8"
625 mm
686 mm
25"
635 mm
Technical Data
Electricity 120 V, 60 Hz, 15 amp
Water pressure4.2 - 140 psi,
0.03-1.0 MPa,
0.3-10 Bar
Heating element1200 watt
Max loading1300 watt
51-5/8"
1311 mm
35" to 35-3/4"
889 to 908 mm
5-3/4" to 6-5/8"
146 mm to 168 mm
4-7/8"
PREPARING THE LOCATION
OPERATING ENVIRONMENT
Do not place this appliance (including the PEX fill hose
and drain hose) where it will be hit by direct sunlight or
exposed to extreme weather conditions.
Do not place the outdoor dishwasher close to a
swimming pool. Water splashing on the machine’s
surfaces can ultimately lead to corrosion (rust).
This appliance is designed to operate outdoors. It is set
to operate within the ambient temperature limits between
50 °F (10 °C) and 104 °F (40 °C). These temperature
limits should not be exceeded.
BUILT-IN INSTALLATION
The dishwasher can be installed in a cabinet, or
completely freestanding. See the illustration to the right
for cutout dimensions.
The best place for your dishwasher is in the kitchen near
the sink. This makes it easier to connect the water and
drain supply lines.
The power-supply receptacle for the appliance shall
be installed in a cabinet or on a wall adjacent to the
undercounter space in whitch the appliance is to be
installed.
The electrical and water supplies should enter through
the area indicated by the shading on the illustration at
right. Preferably, they should come through the right side
of the machine. The access hole must be round and
smooth and no bigger than 1-1/2˝ (38 mm) in diameter.
If the partition is metal, it needs to be covered with
an edge protector and care shall be exercised, when
the appliance is installed or removed, to reduce the
likelihood of damage to the power-supply cord.
3-1/2"
89 mm
Door
3-7/8"
9-1/2"
Cutout Dimensions
U.S.Metric
Height 35-1/4˝ to 36˝895 to 914mm
Width 24-7/8˝ 632 mm
Depth25-1/4˝641 mm
2˝
51 mm
5˝
127 mm
895-914 mm
5-3/4˝
146 mm
25-1/4˝
641 mm
24-7/8"
632 mm
NOTE:
Maintain a 1/8˝ (3 mm) minimum clearance between
unit and cabinet.
35-1/4˝ to 36˝ minimum
45
492183_492185 Install DW Outdoor USA EN Rev 01.indd 42015-01-13 11:14:24
CUSTOMER CARE CENTER 1-800-898-1879 • WWW.ASKONA.COMCUSTOMER CARE CENTER 1-800-898-1879 • WWW.ASKONA.COM
Loading...
+ 8 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.