Ashly KLR-LK2 Installation Guide

Security Knob Installation for KLR Amplifier Level Controls

1 Set knob at desired level.

1

2

2 Carefully remove original
knob by pulling it straight off
without turning shaft.

3 Save original knob for future use.

3

2

4 Install the lock-washer

4

provided with the knob kit.

5

5 Carefully install the

4

security knob by screwing it onto
the potentiometer shaft threads.
The security knob will turn but
the potentiometer shaft will not.

5

6

Turn by hand until finger tight.

6

6 There are holes on the side of the security knob,
which may be optionally used with a small tool
to gently and minimally tighten the knob during installation,
or to loosen the knob for removal later on.
Note: Over-tightening of the security knob
will damage the potentiometer bushing on the amplifier.
Any damage caused by over-tightening will be considered misuse and neglect.

DO NOT OVER-TIGHTEN.

Ashly Audio Inc

847 Holt Road, Webster, NY 14580

Toll Free [phone], Telephone [phone], FAX [phone]

www.ashly.com

All Rights Reserved

Ashly Audio Inc. LIMITED WARRANTY (USA ONLY)

(Other countries please contact your respective distributor or dealer.)

For units purchased in the USA, warranty service for this unit shall be provided by ASHLY AUDIO, INC. in

accordance with the following warranty statement.

ASHLY AUDIO, INC. warrants to the owner of this product that it will be free from defects in workmanship and
materials for a period of FIVE years from the original-date-of-purchase. ASHLY AUDIO INC. will without charge,
repair or replace at its discretion, any defective product or component parts upon prepaid delivery of the product to
the ASHLY AUDIO, INC. factory service department, accompanied with a proof of original-date-of-purchase in the
form of a valid sales receipt. This warranty gives you specific legal rights, and you may also have other rights, which
vary from state to state.

EXCLUSIONS: This warranty does not apply in the event of misuse, neglect, or as a result of unauthorized
alterations or repairs made to the product. This warranty is void if the serial number is altered, defaced, or
removed. ASHLY AUDIO, INC. reserves the right to make changes in design, or make additions to, or improvements
upon, this product without any obligation to install the same on products previously manufactured.

Any implied warranties, which may arise under the operation of state law, shall be effective only for FIVE years from
the original-date-of-purchase of the product. ASHLY AUDIO, INC. shall be obligated to only correct defects in the
product itself. ASHLY AUDIO, INC. is not liable for any damage or injury, which may result from, or be incidental to,
or a consequence of, such defects. Some states do not allow limitations on how long an implied warranty lasts, or
the exclusion, or limitation of incidental or consequential damages, so the above limitations or exclusions may not
apply to you.

OBTAINING WARRANTY SERVICE:

For warranty service in the United States, please follow this procedure:

1) Return the product to ASHLY AUDIO, INC. freight prepaid, with a written statement describing the defect and
application that the product is used in. ASHLY AUDIO, INC. will examine the product and perform any necessary
service, including replacement of defective parts, at no further cost to you.

2) Ship your product to:

ASHLY AUDIO, INC.
Attention: Service Department
847 Holt Road
Webster, NY 14580-9103

Ashly Audio Inc

847 Holt Road, Webster, NY 14580

Toll Free [phone], Telephone [phone], FAX [phone]

www.ashly.com

All Rights Reserved