Ashley 2160412 Instruction Manual

IMPORTANT SAFETY INSTRUCTIONS

WARNING: In order to avoid property damage, serious bodily injury or death, it is important that you read, unders tand and

follow ALL safety instructions. Please keep the safety instructions for future reference.

1. WARNING: Always check under and around the chair before operating to make sure no

children, household pets or objects are under the chair. Never allow children to operate or play on, under or around the

chair. Failure to clear the area under and around the chair before operating may result in serious bodily injury, death

or property damage. Always store the controll er out of reach of children and unplug the chair to prevent children from using

the controller.

2. WARNING: To reduce the risk of electric shock, always unplug the chair from the electrical outlet before moving,

cleaning or servicing.

3. WARNING: To reduce the risk of electric shock, fire, serious bodily injury, death or property damage, only use

the chair indoors in locations free of water. The chair should never be used outdoors.

4. WARNING: To reduce the risk of electric shock, fire, serious bodily injury, death or property damage, never

plug in, use or operate the chair if the cord has been damaged or if the chair becomes wet or has been damaged. Do not use an

extension cord with the chair.

5. WARNING: Do not use the chair to store or support any items including, without limitation, televisions or video

equipment as such items can fall off the chair and cause serious bodily injury or death.

6. WARNING: Use the chair only for its intended use and in accordance with these Safety Instructions and all other product

instructions. Failure to do so may result in serious injury, death or property damage.

7. WARNING: The maximum weight limit of the chair is 300 pounds. Only allow one person to sit on or use the chair

and always sit on the bottom seat cushion only. Never sit on the back of the chair, chair arms or leg rest (if equipped). Using or

operating chair with more than the maximum weight limit or sitting on a part of the chair other than the bott om seat cushion

could damage the chair and/or cause the chair to tip over or collapse resulting in serious bodily injury or death.

8. WARNING: Do not operate chair near or around flammable gases (Including oxygen tanks and masks), liquids or

vapors. Failure to follow this instruction may cause a fire or exp losion resulting in personal injury, death or

property damage.

COVER MATERIAL CARE INSTRUCTIONS

The material covering this piece of furniture is very durable for everyday living. It is recommended by the manufact urer to only clean

this material with water-based cleaning agents or soap. Lightly scrubbing will help with any tougher spots that may have d eveloped.

Always check a small spot of material in an area that is unseen to be sure the cleaning agent being used will not discolor or fade the

material’s finishing. Let the chair air dry and vacuum for the best result.

CHAIR ASSEMBLY - CORD AND POWER TRANSFORMER CONNECTIONS

WARNING: It is important that you read and carefully follow all chai r assembly instructions. Do not plug the power cord into

an electrical outle t until all assembly has been properly completed. Failure to follow all chair a ssembly instructions may cause the

chair to operate improperly possibly resulting in the risk of personal injury or death.

CHAIR ASSEMBLY

Once the chair is remove d from the box, you’ll notice the back is lying on the top of the seat. There are couple of items to remove

from the seat portion of the chair first. Follow below instructions:

1. Some models have back wings which are attached, when unpacking your chair you will find these back wings packed in the back

of the chair base, Figure A #1 Please unpack the back wings and set them aside for installation later.

2. Locate the hardware pack tha t contains the power transfor mer, power cord and the control wand. This can be done by turning the

base over on its arms, you will see the plastic bag tied to the inside of the unit, Carefully cut the ties that hold the bag and remove it.

Dispose of the ties and bag properly. Figure A #2

3. If your chair uses a control wand. Remove the control wand from the plastic bag and connect it to the female plug located in the

left side pocket of the chair, Figure A #3

Figure A

The Power Button is designed to disable the power operation. It is in the cable that connects the motor to the

transformer. It is a press button. When the button is pressed to the off position, the Green Light on the Power button is

not lit. When the button is in the ON position, the Green Light in the Power Button will lit and the unit will operate.

This Cla ss B digital device compli es with part 15 of FCC rules. “Operation is subject to following two conditions: (1) this d evice may not

cause harmful interference, and (2) this device must accept any interference, including interference that may cause undesired operation. To

comply with the FCC RF exposure requirements, no change to the a ntenna or device is permit ted Any change to the antenna or device could

result in the devic e exceeding the RF exposure requi rement and void users right to operate device.

4.INSTALL-FLOOR GLIDES BEFORE USE

Figure D

Figure C

Figure B

Your lift chair has four adjust able floor glides. They are located in the owner’s package and must be installed before use. These glides can be adjusted to level your lift chair. See Figure A.

WARNING: Fa iling to install these floor guides may result in damage to your lift chair, flooring, a nd may cause the

chair to become unstable and fa ll over causing personal injury or death

5. To install the back, align the female brackets in the back with the male brackets in the chair base, slide the back down on the base. See Figure B Push down on the top of the back to lock the back into position. You will hear a click from each side of the chair to ensure the back is locked in properly.

6. If your model has back wings, align the male the female brackets and slide the wing down into place, See Figure C. Please Note there is a

label on the brackets. Please assemble them as 1-1 and 2-2.

7. Plug the Lumbar a nd Headrest, See the Figure D. If your model is Headrest Only, you only need to plug the Headrest.

Figure F

Figure E

Lumbar

Headrest

Lumbar

Headrest

Lumbar

Headrest

Lumbar

Headrest

8. Connect the Power Transformer cable to the corresponding plug coming from the back of the chair Figure A #4

9. Connect the Power Cord into the Power Transformer Figure A #5

10. Connect the power cord into an electrical outlet near where the chair will be used Figure A #6

WARNING: Clear area below chair before operating to reduce risk of injury or death.

The power button is intended to allow you to disable the chair functions.

To stop the chair from functioning using the power button, press the Power Button until the LED light is off. If the chair is not functioning, check the plug in and connection of the cords first (The order is A-B-C-D), see Figure A If all connections are good, verify the LED is lit on the power button. See illustration on bottom of page Figure A-Power Button Be sure cords a re clear from the chair prior to operation.

FLOOR GLIDES

Your Ashley Power Chair has four adjustable floor glides. These glides can be adjusted to level your cha ir on uneven flooring. Remove these floor glides may result in damage to your chair and flooring.

TROUBLE SHOOTING

-PROBLEM

Chair will not operate

-POSSIBLE FACTORS

Trans former may not be connected

-SOLUTIONS

Ensure both wire from the chair and the power cord is firmly connected to the transformer

OPTIONAL LITHIUM BATTERY PACK:

By adding the lithium battery pack to the power transformer, it enhances your existing power transformer with battery back-up feature.

If you wish to purchase the lithium battery pack, plea se contact us a t 1 -844-696-6886.

CONTROL WAND OPERATION

WARNING: Always check under and a round the chair before clo sing from a recline position to make sure no children,

househol d pets or obj ects are under the chair. Never allow children to oper ate or play on, unde r or around the chair. Failure to clear

the area under and around the chair before closing may resul t in serious bodily injury, death or property damage. Always store the

controller out of reach of children and unplug the chair to prevent children from using the controll er.

Control for Headrest and Lumbar

Figure G

Control for Headrest Only

Figure H

Note: USB output - 5V 2A

Control for Headrest and Lumbar

Press and hold to

raise the lumbar

Press and hold to

lower the footrest

Press and hold to

raise the headrest

Press and hold to

raise the back

Press and hold to

recline the back Press and hold to

lower the headrest

Press and hold to

lower the lumbar

Press and hold to

recline the chair

Press and hold to

rais e the footrest

USB

Figure I

lift the chair

Headrest Lumbar

Back

Legres t

Lumbar

Note : USB output - 5V 2A

CUP HOLDER WITH CONTROL SYSTEM FOR HOME THEATER CHAIR MODELS

Note: USB output - 5V 2A

WARNING: Always check under and a round the chair before clo sing from a recline position to make sure no children,

househol d pets or obj ects are under the chair. Never allow children to oper ate or play on, unde r or around the chair. Failure to clear

the area under and around the chair before closing may resul t in serious bodily inj ury, death or property damage.

USB Charging Por t

LED Light

USB Charging Port

LED Light

Figure J

Figure K

Recline

All Close

Headrest Up Headrest Do wn

Recline

All Close

+ 18 hidden pages

Ashley 2160412 Instruction Manual

Specifications and Main Features

Frequently Asked Questions

User Manual