Artusi ASO900RX User Manual for ASO900RX

ASO600RX & ASO900RX
OPERATION MANUAL
APPLIANCES
FOR LIVING
Congratulations, you are now the proud owner of an ARTUSI cooking appliance.
Thank you for purchasing ARTUSI and welcome to the ARTUSI Family.
This instruction manual has been specially created to inform you of the
introduction to getting the very best out of your ARTUSI appliance.
Dear Artusi Customer, please read this user manual carefully before using the
product and, keep it permanently at your disposal.
Note: This user manual is prepared for more than one model. Some of the
features specified in this Manual may not be available on your appliance.
All our appliances are only for domestic use, not for commercial use. Products
marked with (*) are optional.
We present detailed information on each of the features your ARTUSI appliance
consists of. Once you have read this section you will be able to choose the
most appropriate settings for your appliance when cooking different types of
food.
We ask you to read the instructions in this booklet very carefully as this
will allow you to get the best results from using your appliance. KEEP THE
DOCUMENTATION OF THIS PRODUCT FOR FUTURE REFERENCE.
TO REGISTER YOUR PRODUCT WITH ARTUSI, PLEASE FILL OUT THE WARRANTY CARD AT THE END OF THIS BOOKLET AND POST IT TO: REPLY PAID 83617
LEICHHARDT NSW 2040
“THIS APPLIANCE SHALL BE INSTALLED IN ACCORDANCE WITH THE
REGULA TIONS FORCE AND ONLY USED IN A WELL VENTILATED
SPACE. READ THE INSTRUCTIONS BEFORE INSTALLING OR USING THIS
APPLIANCE”
“Conforms with the WEEE Regulations.”
HOOD DUCTING GUIDE
Here are some important points to consider when choosing and/or installing a range hood:
An externally ducted range hood will generally outperform a recirculating range hood.
We discourage the use of flexible ducting as this has a significant negative impact on airflow and noise due to turbulence
caused by the ribs. Instead consider using semi-rigid or rigid duct.
Avoid using a narrower duct than specified as this will reduce airflow; the best performance is obtained when the range hood is installed with a short duct with minimal bends.
To determine the required clearance between the cooktop and the range hood always consult the installation manual for both the range hood and cooktop. The required clearance is the greater of the distance specified in either manual (and a minimum of 600mm between the highest point of the highest burner for gas cooktops).
Five metres is the recommended maximum length for ducting (see diagram 1.). When the ducting exceeds five metres in length the installation of a TD500 or TD350 in-line motor is required, which must be placed one metre from the external vent (see diagram 2.).
1.0m
1.0m
1.0m
90˚ Bend = 1.0m
1.0m
2.0m
1.0m
1.0m
90˚ Bend = 1.0m
3.0m
1.0m
In-line Motor - this needs to run o a separate activation switch to the range hood
External Vent
External Vent
Diagram 1.
Diagram 2.
Information
Caution: Take care when touching the hood as it may become hot due to high heat from steam and fats when cooking.
In certain circumstances electrical appliances may be a hazard. Please pay attention to the following points:
A. Always have air circulating through the room when the hood is in use especially if other appliances burning gas or other fuels are in use. B. Never open the filters to check their state while the hood is in use. C. Do not touch the lightbulb within 30 minutes of using the hood. D. Never flambé under the hood. The flames may cause the hood to catch on fire. E. Do not light gas burners on a gas hob without putting a pan or pot over the flame as the flames may damage the filters and are a fire hazard. F. Never leave frying food unattended as the oil may catch on fire. G. Disconnect the hood from the power supply before any maintenance. H. Never allow persons with reduced physical, sensory, mental capabilities or lack of experience and knowledge, including children under the age of 12, to use the hood without supervision and instruction concerning use of the hood. I. Supervise children to ensure they do not play with the hood. J. Only install this hood over a hob with a maximum of 4 burners/ hot plates. K. Immediately it is damaged replace the power cord with one from the manufacturer, its service agent or similarly qualified to avoid electric shock / fire hazard.
and advice
1
rating label
600-750mm
Remove the hood from the carton and remove all packaging materials. Lay it on a padded / protected surface to prevent damage. Check the voltage and frequency on the rating label inside the hood comply with local standards.
Install the hood no less than 600mm and no more than 750mm above the cooking surface.
Caution: Turn the power off before starting installation.
2
Loading...
+ 11 hidden pages