Artusi ASO600RX User Manual

Cooker
Hood
Model ASO600RX
Instruction manual
Cod:0103082203
In certain circumstances electrical appliance may be a danger hazard. A)There shall be adequate ventilation of the room when the cooker hood is used at the same time as appliances burning gas or other fuels. B)Do not check the status of the filters while the cooker hood is operating. C)Do not touch the light bulb within half an hour after appliance use. D)Do not flambe under the cooker hood. E)Avoid opening gasometer when there is no pan on the stove , F)Constantly check food frying to avoid that the overheated
as it is damaging for the filters and a fire hazard
The negative pressure in the room must not exceed 4 Pa (4x10¯ bar)
other than electricity are simultaneously in operation.
5
J)This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance
by a person responsible for their safety. K)Children should be supervised to ensure that they do not play with the appliance. L)The range hood is intended to be installed over a hob having no more than four hob elements.
M) Indoor use and household use only. N)When the appliance is not in use and before cleaning, unplug the appliance from the outlet.
O)To protect against the risk of electrical shock, do not immerse the unit, cord or plug in water or other liquid. P)CAUTION:Accessible parts may become hot when used with cooking appliances. Q)If the supply cord is damaged,it must be replaced by the manufacturer its service agent or similarly qualified persons in order to
avoid a hazard.
R)There is a fire risk if cleaning is not carried out in accordance with the instructions. S)The details concerning the method and frequency of cleaning. T)The air must not be discharged into a flue that is used for exhausting fumes from appliances burning gas or other fuels.
ɦɦ
And to select ducted operation, insert big mode block into the position indicated in fig 3. Keep the small Handle rail installed on hood.
To select recirculation mode, insert the small mode selection block at the position indicated in fig 4. Keep the big handle rail installed on the hood.
Big mode selection block
Small mode selection block
3
4
Fasten the screws on both side of recirculation vent baffle to avoid vibration when the hood is runing.
Loading...
+ 8 hidden pages