Argox AS-9500 Quick Reference Guide

49-95002-001

This QIG provides demonstration, installation and programming barcode for AS-9500 2D Area-

Imaging Scanner. Product safety information is also included.

Get Connected

AS-9500 2D Area-Imaging scanner can connect to a PC for operation.

1. Power off the PC.

2. Connect the proper interface cable to AS-9500 and to the matching port on the computer.

RS-232:

i. Connect the serial interface cable to the AS-9500 and to the serial port on the computer.

ii. Connect the power supply to the serial interface cable then plug in the power socket.

USB-HID & USB-Virtual COM :

Connect the USB interface cable to the AS-9500 and to USB port on the computer.

3. Power on the PC.

4. Configure the proper interface for AS-9500 by scanning the interface barcode below:

(Intsall the driver from CD-ROM if USB Virtual COM interface is configured.)

The green aiming beam should be centered over the bar code, but it can be positioned in

any direction for a good read.

Linear bar code 2D Matrix symbol

Programming Barcodes

Scanning Mode

● Image: VGA is On, the image is 640x480 pixels. VGA is Off, the image is 752x480 pixels.

● Manual Trigger: The Imager scans until a bar code is read, or until the trigger is released.

● Presentation: The LEDs are either off or at the lowest power for ambient conditions until a bar code

is presented to the imager.

Centering

Scan Centering On, the imager only reads codes that intersect the centering window and specify

the area by the Top, Bottom, Left, or Right barcodes

CenteringScanning Mode

*VGA On

VGA Off

*Manual Trigger

Centering On

*Centering Off

Top of Centering Window

Interface Setting

*USB Virtual COM

RS-232 Interface

USB HID (PC)

Restore to Default Setting Turn on All Symbologies

Default Setting All Symbologies On

USB HID (MAC)

Manual Trigger, Low Power

Safety Information

This dev ice comp lies with the requirement of FCC Part 15 Rules. O pera tion sha ll be subject to the
following two conditions: 1) This device maynot cause harmful interface, and 2) this device must accept
that may cause undesirable operation.

This product conforms to the following standards
EMC: EN55022:2006+A1:2007,class B / EN55024:1998+A1:2001+A2:2003

This device is compliant with the requirements of the European Union Restriction on the use of Hazardous
Substances (RoHS) Directive, 2002/95/EC.

This device is compliant with requirement of BSMI and granted ID No. R3A078

Presentation Mode

Bottom of Centering Window

Left of Centering Window

Right of Centering Window