Argos kent panel 5ft bed ASSEMBLY INSTRUCTIONS

Assembly Instructions - Please keep for future reference
549/3265
Dimensions
Width - 219cm Depth - 167cm Height - 103,3cm
Important - Please read these instructions fully before starting assembly
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
issue 1 - 9/3/16
!
Safety and Care Advice
Important - Please read these instructions fully before starting assembly
Check you have all the
components and tools listed on
the following pages.
Remove all fittings from the plastic bags and separate them into their groups.
Keep children and animals away from the work area, small parts could choke if swallowed.
Make sure you have enough space to layout the parts before starting.
Care and maintenance
Only clean using a damp cloth and mild detergent, do not use
bleach or abrasive cleaners.
During assembly do not stand or put weight on the product, this could cause damage.
Assemble the item as close to its final position (in the same
room) as possible.
Assemble on a soft level surface to avoid damaging the unit or your floor.
Parts of the assembly will be easier with 2 people.
From time to time check that there are no loose screws on this unit.
To redure the likelihood of damaging your product please
ensure that your power drill is set on a low torque setting.
This product should not be discarded with household waste. Take to your local authority waste disposal centre.
Handy Hints
Assemble all parts and bolts loosely during assembly, only once the product is complete should you fully tighten the bolts.
Regularly check and ensure that all bolts and fittings are tightened properly.
Note: if required the next page can be cut out and used as reference throughout the assembly. Keep this page with
these instructions for future reference.
1
If you have damaged or missing components, call the
Components - Panels
Customer Helpline: Argos = 0345 6400800
Please check you have all the panels listed below
3
Side rail (205x4.5x18 cm)
1
Headboard (167x8x103,3 cm)
2
Footboard (167x8x73,3 cm)
6
slat x 14 (155x7x3 cm)
4
Center rail (209x4x6 cm)
3
Side rail (205x4.5x18 cm)
5
Support center rail (31x4x6 cm)
2
Components - Fittings
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more
fittings may be supplied than are required.
A
Bolts x 8
Tools required
B
Phillips screwdriver (medium & large)
Flatblade screwdriver (medium)
7mm Suitable drill bit (for use with wall plug)
Screw 25mm x 1
Drill
C
Allen Key x 1
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
Small hammer
Ruler/tape measure
Eye protection (when using a hammer or glue)
Ruler - Use this ruler to help correctly identify the screws
The screws length is measured from the head to the point (15 mm screw shown).
3
17016015014013012011010090807060504030201005 15 25 35 45 55 65 75 85 95 105 115 125 135 145 155 165
Assembly Instructions
Step 1
Fitting sideframes to headboard and footboard.
Position the headboard 1
and footboard 2 to the end of the siderails 3 . Fit them together, using bolts and allen key as shown.
Perform this step on all
four corners.
C
A
C
A
1
A
A
A
3
A
A
2
A
A
3
A
A
Step 2
Fitting the support center
rail to the center rail.
Insert the support center rail 5 into center rail 4 . Fit them together, using screw .Tighten the screw with the philips head screwdiver.
The support center rail 5
have adjustable feet.
B
5
B
5
4
4
Assembly Instructions
Step 3
Assembling the center
rail.
Place the center rail 4 on the bed frame.
4
Step 4
Place the slats 6 on the
bed frame.
Assembly Instructions
Step 5
Assembly is complete.
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
6
Loading...