Alex Headboard
Step 7
Assembly Instructions
- Please keep for future reference
634/1880
634/1897
634/3541
634/3558
Dimensions
Width x Depth x Height
92cm x 5cm x 53.5/105cm (Single)
136cm x 5cm x 53.5/105cm (Double)
Important
If you need help or have damaged or missing parts, call the
- Please read these instructions fully before starting assembly
Customer Helpline:0345 6400800
Issue 2 - 25/10/14
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
pages 2 and 3.
• Remove all fi ttings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
Care and maintenance
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• Assemble the item as close
to its fi nal position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your fl oor.
• Assembly requires 2 people.
• Do not fully tighten bolts until
the whole bed is assembled.
Do not overtighten the nuts to
avoid causing damage to the
threads.
• From time to time check that
there are no loose bolts or
screws on this unit..
• To reduce
the lik elihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Dispose of all packaging
carefully and responsibly.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
.
H andy
• Assemble all parts and bolts
loosely during assembly,only
once the product is complete
should you fully tighten the bolts.
H ints
• Regularly check and ensure
that all bolts and fittings are
tightend properly..
Note: if required the next
page can be cut out and used
as reference throughout the
assembly. Keep this page with
these instructions for future
reference.
1
If you have damaged or missing components,
Components
Please check you have all the parts listed below
(Single) (Double)
1 Headboard
call the
Customer Helpline:0345 6400800
2 Support arms x 2
2
Components - Fittings
Please check you have all the fittings listed below
Note: The quantities below are the correct amount to complete the assembly. In some cases more fittings
may be supplied than are required.
A
M8 Bolt x 4
Tools required
Phillips screwdriver
B
M8 Flat washer x 4
Ruler - Use this ruler to help correctly identify the screws
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100
3
105
110 115 120 125 130 135 140 145 150 155 160 165 170
Assembly Instructions
Attaching support arms
Attach the two support
arms to the rear of the
headboard using bolts
and washers as
shown.
Assembly is complete.
2
1
A
B
B
A
1
B
A
B
A
B
2
A
2
4
Loading...