ARGENTOSC EB0197 User Manual

90mm

70mm 70mm 70mm

INSTRUCTION MANUAL

Model：EB0197

[EN]
Accessories

TWS earbuds x 1
Charging cable x 1
User manual x 1

Usage
Turn on:

connected with one another.

Turn off:

There are two ways to turn off the earbuds. Once the earbuds have powered down, you will hear

Method 1: Put the earbuds into the charging cradle. The earbuds will turn off and go into charging

them off.
Note: If you turn off only one of the earbuds, the other one will remain connected with the
mobile device and carry on working.

Earbud Pairing

earbuds will become the master earbud.

not display a light.

Note: You can change which earbud is the master whenever you like. While the earbuds are

you want to be master briefly twice. It will become the master.

phone, iPad or other Bluetooth-enabled device, search ‘TWS 12619’ and click on it to connect.
When the earbuds connect with your device successfully via Bluetooth, you will hear

on your device and enjoy it through the earbuds.

Note:

long as 'TWS 12619’ has not been deleted from your Bluetooth list on the device.

established within 3 minutes.

music.

Next song:

skip to the next song. (Beware: if you press and hold for 3 seconds, the earbuds will turn off.)

Answering a call:

answer the call.

Hanging up:
Recall:

phone’s call list.

Stop dialling:
Decline a call:

Charging
Charging the charging cradle: Use the type C charging cable provided to connect the charging

cradle to the power supply. The charging cradle’s blue LEDs will flash while it is charging. Four blue
LEDs will be shown when it is fully charged.
Charging the earbuds: Just place the earbuds into the charging cradle. The earbuds will

The earbuds will display a red LED light while they are charging, and this will turn off when they are
fully charged.

Bluetooth version: V5.0
Bluetooth working range: 10m

SNR: 60db
Frequency response: 20Hz – 20kHz

BT frequency: 2402-2480MHz

- - -

DC in 5V 1A

Warning: To prevent possible hearing damage, do not listen at high volume levels for long periods.

FCC STATEMENT :

This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.

NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

RF warning statement:

The device has been evaluated to meet general RF exposure
requirement. The device can be used in portable exposure condition
without restriction.