Argent EURA Care & Installation Manual
1. INSPECT ALL PARTS PRIOR TO INSTALLATION FOR
SUITABILITY AND/ OR DEFECTS
2. ANY SUSPECTED DEFECT SHOULD BE REPORTED AS
SOON AS POSSIBLE
3. SHOULD ANY PRODUCT BE INSTALLED DESPITE A FAULT
HAVING BEEN FOUND AND REPORTED, ARGENT WILL
NOT ACCEPT LIABILITY FOR THE COST OF LABOUR TO
REMOVE AND INSTALL ANY REPLACEMENT PRODUCT/S
BASIN MIXERS
NOTES PRIOR TO INSTALLATION
1. Please ensure pipework is clear of debris by ushing
lines prior to installation.
2. We recommend hot and cold water isolation stops are
used – not included in supply.
NOTES FOR INSTALLATION
1. Inlet pressure range 100 – 500kpa
2. Maximum hot water temperature 60 C
3. AS/NZS 3500 requires 500 kPa maximum operating
pressure at any outlet within a building
4. Hot & Cold inlets should have equalised water
pressures.
PRESSURE AND TEMPERATURE REQUIREMENTS
21008
ASNZ 3718
• Where the mixer is going into a stone or
laminate top, cut a 35mm ø hole.
STEP 1
• Install the allthread screw into the
bottom of the basin mixer.
• Install basin mixer sealing O ring &
ange(if supplied)
STEP 2
Please direct any
feedback for this product
to Customer Central:
support@customer-
central.com.au or call
1300 364 748
Eura Basin Mixers
Care & Installation Guide
Technical Hotline Customer Central support@customer-central.com.au
1800 356 717 1300 364 748
EURA
BASIN MIXERS
• Feed the two hoses through the hole in
the basin or bench top and attach to
the basin mixer.
STEP 3
• Fit the rubber gasket and xing plate
into position under the basin/ bench
top, fasten with the nut.
STEP 4
• Make sure the hoses are connected to
the correct hot and cold water feed,
and then tighten the nut.
STEP 5
• Open the stop valves (not included in
supply), ush the lines, then close the
mixer lever and check there are no
leakages.
STEP 6
• TWISTING OR STRECHING THE FLEXIBLE
HOSES DURING INSTALLATION MAY
RESULT IN FAILURE, AND WILL VOID THE
WARRANTY.
• AVOID SEVERE BENDS IN THE FLEXIBLE
HOSES AS THIS MAY RESULT IN FAILURE
AND WILL VOID THE WARRANTY.
NOTES TO THE INSTALLER
• THE SPECIAL CHROME FINISH ONLY
REQUIRES CLEANING WITH MILD
HOUSEHOLD DETERGENT AND DRY WITH
A CLEAN COTTON CLOTH TO RETAIN ITS
LUSTROUS SHINE.
• AVOID CLEANING WITH ABRASIVE
MATERIALS OR CLEANERS
CLEANING AND MAINTENANCE
Hot on LHS
Cold on RHS
Hot on LHS
Cold on RHS
Technical Hotline Customer Central support@customer-central.com.au
1800 356 717 1300 364 748
Eura Basin Mixers
Care & Installation Guide
EURA
Loading...