Arboria Seat and Back User Manual

PLEASE READ COMPLETELY BEFORE BEGINNING ASSEMBLY

CHECK BOX FOR THESE CONTENTS

ASSEMBLY INSTRUCTIONS

Arbor Seat and Back

• Seat assembly

• Back rails (total 3)

• Back mounting block (total 2)

• Screws (total 18)

HARDWARE

3” screw (12)

1 5/8” screw (6)

TOOLS YOU WILL NEED

• Philips screwdriver (electric driver recommended)

• Small hammer

• Tape measure

• Pencil

• Four 2” nails

BACK ASSEMBLY

SEAT AND BACK INSTALLED IN ARBOR

STEP 1

• Line up the outer rails to the edge of the back block with the narrow
end pointing upward.

• Secure the outer back rails using the 1 5/8” screws. Center the middle
rail and secure using 1 5/8” screws.

SEAT AND BACK TO ARBOR ASSEMBLY

Block narrow end Back rails

STEP 2

• Determine the height you prefer for the bench seat, usually from 16” to 18” above
ground.

• Deduct 4 3/4” from the height and mark that height on each “leg” of the arbor, this
will locate the bottom of the seat support.

• Drive nails in each of the arbor posts at the marked places.

• Rest the seat on the projecting nails, line it up front and back with the arbor posts.

• Hold the seat firmly to the arbor post and drive 3” screws into all four posts.

STEP 3

• Position back 4” above seat, use books or blocks to support the back and
steady in place

• Position outer edge of back blocks flush with the arbor post.

• Secure the back to arbor using 3” screws.

LWO Corporation, 3841 N. Columbia Blvd., Portland, OR 97217 [phone] [phone] www.arboria.com

4”

4 3/4”

Made in USA 2003