Applied Motion STM23IP-2EE User Manual

STM23 Ethernet Quick
Setup Guide

Requirements

To begin, make sure you have the following equipment:

▪ A small at blade screwdriver for tightening the connectors (included).

▪ A 12-70V DC power supply.

▪ A personal computer running Microsoft Windows 98, 2000, ME, NT, XP, Vista or 7 (32 or 64 bit).

▪ ST Congurator™ software (available at www.applied-motion.com/products/software).

▪ A CAT5 network cable (not included).

▪ For more detailed information, please download and read the STM23 Hardware Manual, available at www.applied-motion.

com/support/manuals.

Step 1

a) Download and install the ST Congurator™ software.

b) If you intend to connect the drive directly to your PC, congure your computer to use IP address 10.10.10.11. (For

instructions on connecting your STM drive to a local area network (LAN), please consult the STM23 Hardware Manual)

c) On the STM23, select switch position 0, which will assign IP address 10.10.10.10. (See the STM23 Hardware Manual

for further details on selecting IP addresses for the drive and PC)

d) Launch the software by clicking: Start / All Programs / Applied Motion Products / ST Congurator

Step 2

Wire the drive to the DC power source.

(Do not apply power until Step 3)

Note - the STM23 accepts DC voltages from 12-70V. If using an
external fuse, we recommend a 4 amp fast acting fuse.

(See the STM23 Hardware Manual for more information about
power supply and fuse selection.)

Connect I/O, if required by your application.

(See the STM23 Hardware Manual for more information about
wiring I/O to the STM23.)

GND

+VDC

920-0058A

Step 3

a) Apply power to the drive. The drive model and rmware revision should

be automatically displayed in the ST Congurator™ software.

b) Follow the conguration instructions in the ST Congurator™ help screens. The ST Congurator™

software can be used to set up your drive to operate in several different modes including: pulse
& direction, velocity (oscillator), streaming commands (SCL), and Q programming mode.

c) ST Congurator™ includes a self test option (under the Drive menu) to verify

that the STM and power supply are correctly wired and congured.

If you have any questions or comments, please call Applied Motion Products Customer Support:
[phone], or visit us online at www.applied-motion.com.

404 Westridge Dr.

Watsonville, CA 95076

Tel: [phone]

Fax: [phone]

www.applied-motion.com

STM23 Ethernet Quick Setup
Guide

920-0058A